• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Help with these Codes

  • Thread starter Thread starter Morales
  • Start date Start date Oct 12, 2005
M

Morales

New Member
Apr 29, 2005
136
0
0
Miami, FL
Oct 12, 2005
#1
  • Oct 12, 2005
  • #1
My cars "Check Engine" light has been coming on and off. It's mostly in the morning when the car's been sitting in the garage over night. It will come on and off for a few min and stop. I plugged in my scanner and pulled these codes.

67 O - Neutral Drive Switch (NDS) circuit failure, circuit open; or AC Input High

67 O - Manual Lever Position (MLP) sensor out of range; or AC input High


10 - ????


31 C - EVP or PFE circut below minimum voltage

I have no idea what's going on or where to begin. Can anyone help me diagnose the problem and help me figure out what part I should change.

Thanks in advance
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Oct 12, 2005
#2
  • Oct 12, 2005
  • #2
Code 67 - clutch not depressed (5 speed) or car not in neutral or park (auto) or A/C in On position when codes where dumped. Possible neutral safety switch or wiring problem. This code may prevent you from running the Key On Engine On tests. You can generally ignore this code, since it has no effect on engine performance.

Code 10 - No code 10 in any of the listing I have. Please try again.

CODE: 31 (KOEO) - EVP circuit below minimum voltage. Vref (5 volt reference voltage supplied by the computer) missing or broken wire or bad connection in circuit. Use a DVM to check for 5 volts on the orange/white wire. If it is missing, look for +5 volts at the orange/white wire on the TPS or MAP sensor located on the firewall near the center of the car. Use the black/white wire for the ground for the DVM.
With the sensor removed from the EGR and still connected, press the plunger and watch the voltage change on the brown/lt green wire. Pull the passenger side kick panel and measure the voltage at the computer. You will need to remove the plastic cover over the wires and probe them from the backside. A safety pin may prove very useful for this task. Use pin 27, EVR input (brown/lt green wire) and pin 46, signal ground (black/white wire) to measure the voltage. The orange/white wire is Vref and should always be 5 volts -/+ .25 volt. Be sure to measure Vref at the EGR sensor to rule out any broken wires or bad connections.
 
M

Morales

New Member
Apr 29, 2005
136
0
0
Miami, FL
Oct 12, 2005
#3
  • Oct 12, 2005
  • #3
Man that sounds real complicated.. thanks for the help
 

sunil6784

Member
Mar 31, 2005
620
0
18
Boston, MA
Oct 12, 2005
#4
  • Oct 12, 2005
  • #4
JRickhker, Cant Code 67 come on if the defrost is on also? thats what happened to me. I turned the defrost off and I didn't get the code.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Oct 12, 2005
#5
  • Oct 12, 2005
  • #5
sunil6784 said:
JRickhker, Cant Code 67 come on if the defrost is on also? thats what happened to me. I turned the defrost off and I didn't get the code.
Click to expand...
The Defrost kicks on the A/C to dry out the air.
 
You must log in or register to reply here.

Similar threads

T
Drivetrain TREMEC TKX 1–2 Grinding Issue at ~4,000 Miles + Poor Warranty/Customer Service Experience
  • Ttopfoxguy
  • Oct 10, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
319
Fox 5.0 Mustang Tech Oct 15, 2026
JMG9350
J
J
Thanks for the information on codes 31,34,44 and 94!
  • JK86LX50
  • Mar 5, 2025
  • The Welcome Wagon
Replies
3
Views
375
The Welcome Wagon Aug 5, 2025
gkomo
Progress Thread Giving an abandoned 88 GT project a new chance at life
  • jaketractor
  • Jan 9, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
27
Views
2K
Fox 5.0 Mustang Tech Jul 20, 2025
Noobz347
SURGING IDLE / NO IDLE CHECKLIST FOR 1996–1998 MUSTANG GT (4.6L 2V) - Work In Progress
  • Noobz347
  • Aug 30, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
1K
1996 - 2004 SN95 Mustang -General/Talk- Aug 30, 2025
Noobz347
R
93 LX 2.3 Trouble codes 53, 85, 21 help
  • Rickshaw302
  • Apr 15, 2025
  • 2.3L (N/A & Turbo) Tech
Replies
17
Views
835
2.3L (N/A & Turbo) Tech Apr 18, 2025
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?