• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

Hood Flew-up and Damaged Convertible

  • Thread starter Thread starter phatwebs
  • Start date Start date Nov 17, 2008
P

phatwebs

New Member
Jul 10, 2007
31
0
0
Seattle, WA
Nov 17, 2008
#1
  • Nov 17, 2008
  • #1
Yup, no hood pins allowed this to happen yesterday @ 70-75MPH on the highway. Fortunately, I was the only one in the car and no other cars where around. I pulled over to the shoulder at a rolling stop. I have learned this happens more frequently than I care to read about. I plan to get estimates for the repairs. My questions to you fine folks are:
  1. Is the windshield frame repairable? It looks like the crossmember section between the tops of the A-pillars could be removed and replaced. Or, is the scope of this repair much greater?
  2. How much would you "guesstimate" this would cost to repair? I don't want to get ripped-off.
  3. Do you have recommendations to source the parts needed to repair all of this damage? I will need: hood, hood hinges,hood pins, cowl cover, wipers, windshield (and windshield frame?) and probably molding.
More hi-res photos of the carnage are here.

Thank you,
Paul





 

revhead347

Apparently my ex-husband made that mistake.
20+ Year Stangneter
Jun 14, 2004
9,297
1,641
214
Acworth, GA
Nov 17, 2008
#2
  • Nov 17, 2008
  • #2
Looks repairable. Usually a hood flying up is $2000. +$40 for hood pins this time round.

Kurt
 

ProKiller

Founding Member
Apr 26, 2002
3,064
15
78
PA
Nov 17, 2008
#3
  • Nov 17, 2008
  • #3
that really sucks man. its good thats all that happened. you could have been seriously injured if not wrecked the car when it happened. your lucky.
 
P

phatwebs

New Member
Jul 10, 2007
31
0
0
Seattle, WA
Nov 17, 2008
#4
  • Nov 17, 2008
  • #4
ProKiller said:
that really sucks man. its good thats all that happened. you could have been seriously injured if not wrecked the car when it happened. your lucky.
Click to expand...

Isn't that both true and ironic? I am unlucky this happened in the first place and lucky this incident didn't cause a wreck and injury to myself or others.

Paul
 

95opal

5 Year Member
Nov 16, 2004
449
20
39
Nov 17, 2008
#5
  • Nov 17, 2008
  • #5
I dont know but those A-pillars look bad. Thats going to be expensive.
Glad you didnt get hurt in all this I know its pretty scary when they go up as I have lost a few hoodsin the past. Another reason to run pins in ANY aftermarket hood.
 
P

phatwebs

New Member
Jul 10, 2007
31
0
0
Seattle, WA
Nov 17, 2008
#6
  • Nov 17, 2008
  • #6
I am hoping the A-pillars are OK and just the cross-member can be replaced. I looked under the trim pieces and see it is spot welded to the tops of the A-pillars. And in doing so, straighens them up so the top closes and seals. The doors close and windows seem to seal OK against the A-pillars. The top and windows where down when this occurred.

Paul
 

Zero Signal

Active Member
Feb 24, 2003
2,633
2
46
Tucson, AZ
Nov 17, 2008
#7
  • Nov 17, 2008
  • #7
Happened to me at 50mph. Stupid aftermarket hood never latched very well and I paid for it. Luckily the a-pillars were unscathed, but the roof and windshield took the brunt of it. I managed to knock out the roof dent myself. The wipers never worked since.

I managed to find a pretty nice black stock hood for $200 at a scrap yard though
 

warriorpluto

Member
Aug 1, 2007
267
1
19
monroe.LA
Nov 17, 2008
#8
  • Nov 17, 2008
  • #8
Zero Signal said:
Happened to me at 50mph. Stupid aftermarket hood never latched very well and I paid for it. Luckily the a-pillars were unscathed, but the roof and windshield took the brunt of it. I managed to knock out the roof dent myself. The wipers never worked since.

I managed to find a pretty nice black stock hood for $200 at a scrap yard though
Click to expand...

damn your junkyard is high. a hood at the local u pull it is only $35
 

Zero Signal

Active Member
Feb 24, 2003
2,633
2
46
Tucson, AZ
Nov 17, 2008
#9
  • Nov 17, 2008
  • #9
This hood's paint was mint like it came off a brand new car and a perfect color match so it was worth it to me over prepping/painting a new or used hood. It also came from a Pheonix based mustang specific place which also didn't help the cost.
 

Pokageek

Active Member
Jun 10, 2005
2,767
0
46
MA, USA
Nov 17, 2008
#10
  • Nov 17, 2008
  • #10
UH Oh, I have the same style hood. But it closes tight and has metal latches unlike other aftermarket hoods. It does not move in the wind. Was yours the same as this??
 
P

phatwebs

New Member
Jul 10, 2007
31
0
0
Seattle, WA
Nov 17, 2008
#11
  • Nov 17, 2008
  • #11
Pokageek said:
UH Oh, I have the same style hood. But it closes tight and has metal latches unlike other aftermarket hoods. It does not move in the wind. Was yours the same as this??
Click to expand...

Yes, the latch area is reinforced with metal plates. Somehow, the hood came loose from the latch. With all the carnage, it is impossible right now to determine root cause. "Cobra R Part - 117" is stamped underneath the driver's side front part of the hood. I think my hood is an older Cervini's brand hood. Although I can't find Cervini stamped anywhere.

https://www.cervinis.com/product.aspx?car=1&id=1127

I like the Ford Racing Hood Pins with lanyards.

Cheers,
Paul
 

toyman

10 Year Member
Jul 19, 2007
1,944
54
79
Vernon BC
Nov 17, 2008
#12
  • Nov 17, 2008
  • #12
This is where comprehensive insurance pays off. I'm guessing you didn't carry any. Tough break but as others noted it could have been more serious.
 

Pokageek

Active Member
Jun 10, 2005
2,767
0
46
MA, USA
Nov 17, 2008
#13
  • Nov 17, 2008
  • #13
phatwebs said:
Yes, the latch area is reinforced with metal plates. Somehow, the hood came loose from the latch. With all the carnage, it is impossible right now to determine root cause. "Cobra R Part - 117" is stamped underneath the driver's side front part of the hood. I think my hood is an older Cervini's brand hood. Although I can't find Cervini stamped anywhere.

https://www.cervinis.com/product.aspx?car=1&id=1127

I like the Ford Racing Hood Pins with lanyards.

Cheers,
Paul
Click to expand...

Thanks. Yes your hood has more of a slant near the windshield whereas mine is more perpendicular. I think I have a different hood but I may be getting pins now. Thanks for the heads up.

BTW I think there was a recall on original ford latches. Mine is new because I was in a light front end collision a coupla years ago.
 

revhead347

Apparently my ex-husband made that mistake.
20+ Year Stangneter
Jun 14, 2004
9,297
1,641
214
Acworth, GA
Nov 17, 2008
#14
  • Nov 17, 2008
  • #14
I think your A-pillars are fine. They are really strong on the convertible models. It's not a lot to repair, but it's going to nickel and dime you to death. Paint matching alone gets expensive.

Kurt
 

95opal

5 Year Member
Nov 16, 2004
449
20
39
Nov 18, 2008
#15
  • Nov 18, 2008
  • #15
revhead347 said:
I think your A-pillars are fine. They are really strong on the convertible models. It's not a lot to repair, but it's going to nickel and dime you to death. Paint matching alone gets expensive.

Kurt
Click to expand...



Thats the killer trying to match the opal paint, It aint going to happen. Dont ask how i know.
 

revhead347

Apparently my ex-husband made that mistake.
20+ Year Stangneter
Jun 14, 2004
9,297
1,641
214
Acworth, GA
Nov 18, 2008
#16
  • Nov 18, 2008
  • #16
Canary yellow is a bitch to match too. Mine isn't perfect.

Kurt
 

Zero Signal

Active Member
Feb 24, 2003
2,633
2
46
Tucson, AZ
Nov 18, 2008
#17
  • Nov 18, 2008
  • #17
Maybe just paint the A-pillar and across the windsheid black to match the top
 
You must log in or register to reply here.

Similar threads

Fox Hood flew up while driving.
  • 93CalypsoConvert
  • Nov 15, 2021
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
18
Views
5K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 20, 2021
Bree
SOLD Restored 1986 Mustang GT
  • MRaburn
  • Jul 12, 2021
  • Fox Body Mustangs For Sale (1979-93)
Replies
7
Views
9K
Fox Body Mustangs For Sale (1979-93) Jul 12, 2022
Noobz347
14 months later... she's back on the road
  • mikestang63
  • Mar 2, 2019
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
23
Views
3K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 12, 2019
FastDriver
Progress Thread Calypso Cash Pit
  • JKWilson61
  • Jun 7, 2019
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2 3
Replies
44
Views
9K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Dec 13, 2019
General karthief
My Fox(es) In Surgery - Looking Like A Car Again,sort Of
  • mikestang63
  • Dec 10, 2017
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 4 5 6
Replies
105
Views
10K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 20, 2018
mikestang63
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?