Hood latch problem

trublustallion

Founding Member

Dec 15, 2001

386

1

16

El Paso, Texas

Apr 20, 2008

#1

• Apr 20, 2008

• #1

Ok, so I finally painted my hood, but it does not want to snap on to the latch. It goes through the yellow handle ok, but it just wont go enough to push the part that secures it. I tried washers, aligning and re-alinging it. So what i have now is a hood that is just held on by hood pins and no security. Can anyone help me? The hood pins I have now I bought at autozone, which are ok, but if I cant latch the hood on, I need pins that lock. Anyone have locking pins on theirs, where'd you get them?



:SNSign:

 

C

ceracer33

New Member

Aug 30, 2005

118

1

0

Apr 20, 2008

#2

• Apr 20, 2008

• #2

sounds like the latch needs to be raised up. take it off and grind the two little pegs on the backside off so that u can get some adjustment on it, then keep moving it up a little at a time until it closes the way u like it.

 

nyuk98gt

15 Year Member

Oct 10, 2000

1,427

6

79

Chesterfield, MO

Apr 21, 2008

#3

• Apr 21, 2008

• #3

Hey, those dowels will come out with a pair of pliers so no grinding is required!

Chris

 

Turbo92PGT

Member

Feb 17, 2003

746

0

16

Auburn Washington

Apr 22, 2008

#4

• Apr 22, 2008

• #4

Might sound stupid but is the hole cut into the hood large enough to even fit the latch in it? the hood I bought wasn't made well and the opening in the hood for the latch wasn't big enough to fit the latch in it so I ground it out with the die grinder and all was well.

On a side note, remove the latch all together. Fit the hood to the fenders and bumper. Once you get it fitting ok, then put the latch in. And adjust it accordingly, make sure its not too high because your hood will flop around, use the rubber bumpers to adjust the height and put a little pressure on your hood.

 

trublustallion

Founding Member

Dec 15, 2001

386

1

16

El Paso, Texas

Apr 23, 2008

#5

• Apr 23, 2008

• #5

cool, im going to try the peg removal, i was just afraid they were very important or something. And yeah, the hole is big enough for the latch, the lock just wont reach it by like ~1cm.

thanks, hope it works

 

the98stang

Active Member

Aug 12, 2005

2,408

0

47

Clovis, CA

Apr 25, 2008

#6

• Apr 25, 2008

• #6

I went through this same ****. Bought a new latch assembly, problem solved. Wasted HOURS shimming, bending, cutting etc.

 

RedBullitt

New Member

Jul 7, 2004

462

0

0

Morgantown WV

Apr 25, 2008

#7

• Apr 25, 2008

• #7

peg removal saved my butt, make sure you mark the latch where it works the best once you figure it out. mine slowly works around to where it doesnt latch as well eventually. i just keep it lined up and it fine