How can you trace down something in the car drawing power from the battery?

K

kravamagaguy

New Member

Jul 17, 2007

20

0

0

Dallas, Texas

Jul 19, 2007

#1

• Jul 19, 2007

• #1

OK thanks again to everyone for there help on my major last car issue.

This one is when the car sits and is not driven for more then 2 or 3 days the car is dead and will not start. The altenator is good.

The battery shows 11.3 volts sitting, but when you go to turn it over on the acc post. it goes to 9.1 volts. Then if you try and turn it over it goes down to 5 volts.

I do have a big stereo in it, and an aftermarket alarm system.

Any help on this would be appreciated.


Thanks again.

 

samickguy15

Member

Sep 1, 2005

404

0

16

Delavan, IL

Jul 19, 2007

#2

• Jul 19, 2007

• #2

Get a ammeter that clamps around wires. I believe Sears sells them. It could be a bad connection at the battery also. If you notice alot of corrossion build up in a short period of time I would suspect that. Otherwise I would buy the ammeter and start tracing.

 

Distortion 5.0

New Member

Jul 8, 2005

114

0

0

Jul 19, 2007

#3

• Jul 19, 2007

• #3

You can also use a meter with probes to check each fuse to see if any of the circuts are drawing power with the key off.

Tech's call it a "parasitic drain" .

Good Luck, wires are no fun.


EDIT:

If it only reads 11v after a good drive, you might have another problem.
A good battery should hold up to a 14.4V surface charge w/ 0.0 load.
Maybe take it to the zone and have it checked before you go chasing wires...

 

K

kravamagaguy

New Member

Jul 17, 2007

20

0

0

Dallas, Texas

Jul 19, 2007

#4

• Jul 19, 2007

• #4

Ok.

Yes i had the ZONE check it out, they said it was bad. But the car has been doing this for years. I'm thinking its the stereo or alarm maybe?

 

jrichker

StangNet's favorite TOOL

In Remembrance. Thank you for your contributions

Mar 10, 2000

27,512

2,813

234

Dublin GA

Jul 19, 2007

#5

• Jul 19, 2007

• #5

Typically it is something draining the battery. Small things like glove box or courtesy lights are often the culprits. If you have an aftermarket stereo or alarm system, it is also suspect.

The ideal method is to disconnect the positive terminal on the battery, and connect a Digital Multimeter (DVM) between the positive terminal on the battery and the positive cable. Set the DVM on a low current scale of 2-5 amps if it doesn't auto range. Watch the current draw, and then start pulling out fuses. When you see a sudden drop in the current, that circuit is the likely culprit. Note that the computer, radio & clock will draw less than 1/10 amp to keep the settings alive.

 

J

Jack's95gt

Member

Aug 15, 2004

443

1

18

Huntingdon Valley, PA

Jul 19, 2007

#6

• Jul 19, 2007

• #6

I had the same type of problem. I pulled all the fuses and it still went dead after a few days. I bought a battery charger and used it every couple of days. The battery went bad from all the discharging. After a new battery, I bought a battery cut off switch that attached to the battery post and I cut off the battery after every ride. I found the problem by accident went I pulled the engine. The positive battery cable rubbed against the K member and created a short. I would have never found this. It was completely hidden.

 

Mustang5L5

That is…until I whipped out my Bissell

Mod Dude

Feb 18, 2001

43,265

17,952

224

Massachusetts

Jul 19, 2007

#7

• Jul 19, 2007

• #7

Are your connections good??

 

HISSIN50

"How long does it take to get help in here?

15 Year Member

Nov 29, 1999

31,179

34

129

Jul 19, 2007

#8

• Jul 19, 2007

• #8

A bad battery can act like this. It just gets worse over time till it's a total PITA. In this case, there is no excessive accessory draw or anything - it's simply the battery.

 

P

pastfast125

New Member

Jul 15, 2007

12

0

0

Jul 19, 2007

#9

• Jul 19, 2007

• #9

Mine kept draining all the time, found out it was just because my connections that clamp on the terminals were worn out and not clamping tight enough. Check those out, like 4$ to replace.

 

K

kravamagaguy

New Member

Jul 17, 2007

20

0

0

Dallas, Texas

Jul 20, 2007

#10

• Jul 20, 2007

• #10

Here you go.

Yes Connections are good.

Replaced the postive cable. Need to replace the negative cable.- Even though it does not look bad. Has brand new altenator- and also have a brand new high current alt. in the box waiting to go on- I think it's 160 amp-3g, with all the proper wiring etc. from rjm injection.

Has brand new battery, as well.

And for everyone that wants a good laugh, after all my issues with getting the car running correctly as in my last post, guess what happens yesterday? The starter went out! Ugggggggggggg!!

Thus is life! Now over 70% of the car has new parts. But it's a almost perfect 5.0 lx coupe ?!?!? and those are very hard to find! esp with only little milage!

lol.

 

Roland69

Sergeant Tangnet

Sep 17, 2005

2,867

3

58

Port Elgin, Ontario

Jul 20, 2007

#11

• Jul 20, 2007

• #11

jrichker said:

Typically it is something draining the battery. Small things like glove box or courtesy lights are often the culprits. If you have an aftermarket stereo or alarm system, it is also suspect.

The ideal method is to disconnect the positive terminal on the battery, and connect a Digital Multimeter (DVM) between the positive terminal on the battery and the positive cable. Set the DVM on a low current scale of 2-5 amps if it doesn't auto range. Watch the current draw, and then start pulling out fuses. When you see a sudden drop in the current, that circuit is the likely culprit. Note that the computer, radio & clock will draw less than 1/10 amp to keep the settings alive.

Click to expand...

that is how I was tought except I was told to use the neg side...I don't know why but I would think you could use one or the other couldn't you

 

B

BullittAndy

New Member

Nov 9, 2003

139

0

0

Jul 21, 2007

#12

• Jul 21, 2007

• #12

Check the sunvisor lights if you have them.

 

Roland69

Sergeant Tangnet

Sep 17, 2005

2,867

3

58

Port Elgin, Ontario

Jul 21, 2007

#13

• Jul 21, 2007

• #13

we have run into that before, or a glove box light, ashtray light, hood lights ect

 

jrichker

StangNet's favorite TOOL

In Remembrance. Thank you for your contributions

Mar 10, 2000

27,512

2,813

234

Dublin GA

Jul 21, 2007

#14

• Jul 21, 2007

• #14

Roland69 said:

that is how I was tought except I was told to use the neg side...I don't know why but I would think you could use one or the other couldn't you

Click to expand...

Using the negative side prevents nasty accidents like shorting the wrench to ground while disconnecting the battery cable. It probably is a better method.

 

onefstsnake

New Member

Nov 25, 2005

792

1

0

Northern VA

Jul 21, 2007

#15

• Jul 21, 2007

• #15

I know stangs dont have On Star, but I knew a guy who found that his On Star transmitter was drawing 2.5 Amps with the car off...

Bulbs dont draw much and neither do bad connections, but they add up quick.
Check the grounds?