• Mustang Forums
  • 2005 - 2014 S-197 Mustang -General/Talk-
  • 2005 - 2009 Specific Tech

How much Trann Fluid is to much T-3650

  • Thread starter Thread starter 05SonicBlueGT
  • Start date Start date Jun 17, 2005
0

05SonicBlueGT

New Member
Mar 31, 2005
36
0
0
Mississippi
Jun 17, 2005
#1
  • Jun 17, 2005
  • #1
I was changing my trans fluid in the T-3650, I had it put on ramps in the front and on the ground in the back. I put over 3.5 quarts but less than 3.8 quarts when it started running back out. I know the book says 3.2 quarts. I was thinking 4 quarts. I can't seem to get to the trann. with it on the ground to check it while it is level. Is this to much fluid. Thanks


I was able to get level, and I drained it down the the fill hole stopped dripping
but not the other 1/2" below the fill hole. Maybe I'll try something esle. I think this the level that the site is talking about on change to Royal Purple to fix there problem.
 
O

Over's GT

New Member
Mar 31, 2005
72
0
0
Jun 17, 2005
#2
  • Jun 17, 2005
  • #2
where is the fill, on side/front or side/rear

I think the car needs to be level (like on a lift) to get good reading, I would go to the spec. amount

why did you change so early, did you put in something special?
 
0

05SonicBlueGT

New Member
Mar 31, 2005
36
0
0
Mississippi
Jun 18, 2005
#3
  • Jun 18, 2005
  • #3
I am putting Amsoil all the way through. The fill line is in the back.
 

crash

Founding Member
Aug 12, 1999
337
0
0
Dallas, Tulsa
Jun 18, 2005
#4
  • Jun 18, 2005
  • #4
If there is a window with a full line, go with it. I will have to take a look. Most don't (T-5 or T-45).

If NOT...Fill it to the BOTTOM of the threads on the FILL plug. Allow excess to drain to the point of DRIPPING, not running out.

Or add what the manual says, but it will be correct PLUS OR MINUS. Now, Make SURE you have the correct plugs. It will be stamped FILL and DRAIN (Drain is the lowest plug).

This is true on the following as well...

M5OD (Trucks)
T-5
T-45
 

hotrodnut

Member
Jul 12, 2004
672
0
17
North Florida
Jun 18, 2005
#5
  • Jun 18, 2005
  • #5
On page 218 your manual says, "For vehicles equipped with a V-8 engine the correct manual transmission fill level is 1.3 cm (1/2 inch) below the edge of the filler hole." That is assuming the vehicle is setting level of course.

On page 221 as you noted the quantity is 3.2 quarts which should be all you need to put in.

Then on page 222 it says in subnote 5, "Service refill capacity is determined by filling the transmission to the bottom of the filler hole with the vehicle on a level surface." That fill level conflicts with what page 218 says, go figure??

Either way as long as you have the 3.2 quarts in it then wherever the level is it is good to go!
 

crash

Founding Member
Aug 12, 1999
337
0
0
Dallas, Tulsa
Jun 18, 2005
#6
  • Jun 18, 2005
  • #6
I have seen many service manuals that use the latter... LOL! And yes, you do want to be level...
 
D

DENVER05GT

New Member
Dec 5, 2004
14
0
0
Jun 18, 2005
#7
  • Jun 18, 2005
  • #7
I remember reading somwhere that the 3650 is very specific about 1/2" below the fill hole. I recall that if it is overfilled it can cause the occasional second gear grind.
 

mogs01gt

Founding Member
Jul 22, 2002
3,113
30
119
Ohio
Jun 20, 2005
#8
  • Jun 20, 2005
  • #8
I would put a little less than 4 quarts in. Around 3.5-3.8 quarts.
 
You must log in or register to reply here.

Similar threads

Drivetrain 83’ Glx convertible C5 Trans help!
  • JacksonJared2113
  • Dec 25, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
396
Fox 5.0 Mustang Tech Dec 26, 2025
JacksonJared2113
O
TransGo shift kit question?
  • optionizerSS
  • Jul 5, 2023
  • 1994 - 1995 Specific Tech
Replies
8
Views
2K
1994 - 1995 Specific Tech Jul 7, 2023
AeroCoupe
K
TKX Transmission Shifting Problem
  • KWC156
  • Jun 23, 2025
  • Other Auto Tech
  • 2
Replies
21
Views
3K
Other Auto Tech Jun 13, 2026
427nostang
4
4.6 question for those in the know....
  • LILCBRA
  • Aug 30, 2024
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
15
Views
1K
2005 - 2014 S-197 Mustang -General/Talk- Sep 4, 2024
Adieu
M
Progress Thread mnky99 2001 V6 evap core, ac compressor, heater core replacement
  • mnky99
  • Sep 5, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
516
1996 - 2004 SN95 Mustang -General/Talk- Sep 5, 2025
mnky99
M
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 2005 - 2014 S-197 Mustang -General/Talk-
  • 2005 - 2009 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?