lib88stang Founding Member Mar 24, 2001 154 1 18 Pa Aug 23, 2004 #1 Aug 23, 2004 #1 I have a set of E7TE heads that already have the crane stud mount conversion done on them. How do I get the studs out of the heads???? thanks
I have a set of E7TE heads that already have the crane stud mount conversion done on them. How do I get the studs out of the heads???? thanks
dastang2 Active Member Dec 11, 2003 2,020 0 46 tx Aug 23, 2004 #2 Aug 23, 2004 #2 you can buy a special tool to do it or get 2 nuts that fit and screw them both on but not all the way down. then get a wrench and try to loosen the bottom nut. the upper nut will not let it turn anymore causing the whole stud to loosen up
you can buy a special tool to do it or get 2 nuts that fit and screw them both on but not all the way down. then get a wrench and try to loosen the bottom nut. the upper nut will not let it turn anymore causing the whole stud to loosen up
Rick 91GT Mustang Master Nov 29, 1999 9,692 95 99 PA Aug 23, 2004 #3 Aug 23, 2004 #3 The conversions I have seen that use the ARP studs un bolt.....
dastang2 Active Member Dec 11, 2003 2,020 0 46 tx Aug 23, 2004 #4 Aug 23, 2004 #4 sure do, i was looking at summit and they did have a hex on it. somebody just put studs on it which won't hurt but it makes it harder to take off.
sure do, i was looking at summit and they did have a hex on it. somebody just put studs on it which won't hurt but it makes it harder to take off.