How to make 10.5in Cobra R's fit?

MY86GTVERT

I am Adam Sandler's GAY brother!
Founding Member
Jul 18, 2002
120
0
0
43
Harrisburg, PA
the title about explains it all. how do u go about doing this with out getting extra long studs? i wouldnt trust too much power behind really long studs. unless im just being paranoid about that.

has anyone else done it?

what size tire would u need also?
 
Not quite sure... I don't know how much tha wells changed from '86 to '87... i do know that the wells in '87s to '89s (like i have) were smaller than the newer year foxes... i had a small problem with my 275s rubbin... but a set of 1/4" spacers on tha back took care of that
 
i see cobra R's all the time. but never had i seen the 10.5in ones. after i wrecked the vert i sold it. the guy sold the wheels off it, its sitting on 14in steelies right now. and im buying it back now and its gonna need some wheels. i always like the cobra r's
 
I thought the inner fender difference between older/newer foxes was just the front? I might be wrong...

I would also think you couldn't run tailpipes (at least not standard aftermarket catbacks) with 315s, considering how close it sits to my 245s as is.
 
I have the 10.5 with 285's on the rear of my 89 hatch, i had to take off the quad shocks and beat on the inner well with a 3 pound sledge to stop them from rubbing the inside then i got 5/16 spacers and they would rub on the fender, took the grinder to the fender lip and groung off almost a 1/4 inch, haven't had them rub since