HURST SHIFTER! HELPPPPPP

MustangOwner

Banned
Dec 13, 2006
160
0
0
I'm trying to install my Hurst comp shifter in my 1991 Stang. Well my dust cover is like stuck on there. The back 2 bolts, the bottom clip broke so they just spin. And the front to i can even budge. How would you go about getting this off? Breaking it is not an issue as i wont be reusing it ha. Just get a dremel up under the car and dremal them off? maybe? idk HELP
 
I could put it up on my hoist at the shop in the spring and get to the rear two. But the front 2 wont even move. So i think i might have to dremel them off or something. im not exactly sure.
 
Had the SAME EXACT PROBLEM installing my pro 5.0 shifter and I just got a cutting bit on teh dremel and cut the pos off! Takes a little time, but gets the job done. Then I used self-tapping screws to reinstall. Good luck :D