• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-

I Hate Odd Noises

  • Thread starter Thread starter ace305
  • Start date Start date Oct 10, 2017
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 10, 2017
#1
  • Oct 10, 2017
  • #1
I have a 2001 Bullitt. I get this vibration/grown when taking off in first normally. cant seem to figure it out. New struts, springs, rotors, brakes, wheel hubs. the sound last a second. only at certain rpm. almost like the car has to hit a certain vibration from accelerating before it happens. only hear it on acceleration.

are there any points I could grease or lubricate ?

thanks
 
Last edited: Oct 21, 2017

DSG_Mach

Active Member
Jul 23, 2016
115
16
38
Oct 10, 2017
#2
  • Oct 10, 2017
  • #2
Could be bad motor mounts, or unbalanced driveshaft. Is it automatic or standard?
 
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 10, 2017
#3
  • Oct 10, 2017
  • #3
DSG_Mach said:
Could be bad motor mounts, or unbalanced driveshaft. Is it automatic or standard?
Click to expand...
hey is a standard. how to check for bad motor mount and unbalanced drive shaft?

thanks for the reply
 

DSG_Mach

Active Member
Jul 23, 2016
115
16
38
Oct 11, 2017
#4
  • Oct 11, 2017
  • #4
ace305 said:
hey is a standard. how to check for bad motor mount and unbalanced drive shaft?

thanks for the reply
Click to expand...

Bad motor mounts would have the motor shaking around a lot more than normal but if they were bad I would imagine you would notice it when driving at any speed. The driveshaft you can go to a shop and have them balance it for you. A unbalanced driveshaft would cause noticeable vibration but I could be wrong.
 
R

rlauzon

Active User
Sep 20, 2017
12
4
13
Oct 11, 2017
#5
  • Oct 11, 2017
  • #5
What are the chances of it being an un balanced shat? what would cause the shaft to go out of balance?
 
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 11, 2017
#6
  • Oct 11, 2017
  • #6
thanks everyone. Its actually not a vibration issue that i feel, its more like something vibrating causing a sound.
 
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 12, 2017
#7
  • Oct 12, 2017
  • #7
Could it be a bad lower ball joint? the boots are torn. I purchased the car used. No telling how long its been torn. can ball joints make noises other than "clunking sounds" ?
 

Neuron

5 Year Member
Nov 6, 2016
859
192
93
Oct 12, 2017
#8
  • Oct 12, 2017
  • #8
Most of the time you can check mounts by a visual inspection, have also put a piece of wood under the pan and gently tried to raise the engine/trans. and watching the mounts(usually separation of the rubber from the steel).
 

Mattstang04

15 Year Member
Sep 15, 2006
1,152
144
104
St. Louis, MO
Oct 12, 2017
#9
  • Oct 12, 2017
  • #9
Ball joints can make a metallic squeaky sound but its more a turning thing than an acceleration or rpm thing.

Maybe not the whole drive shaft but the u joints could also be shot.
 
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 21, 2017
#10
  • Oct 21, 2017
  • #10
FOUND IT! its in the rear passenger brake. When I go supper slow it sounds like its a warped rotor. gets loud than goes away gets loud then goes away. if I pull the emergency brake a little it shuts up. the rotors are brand new. any advice?

thanks
 

Neuron

5 Year Member
Nov 6, 2016
859
192
93
Oct 21, 2017
#11
  • Oct 21, 2017
  • #11
I would look it over and if nothing obvious I would trade it with the other side's rotor and see what happens.
 
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 21, 2017
#12
  • Oct 21, 2017
  • #12
should I had a grease to back of pads? its a vibration hummm sound.
 

General karthief

wonder how much it would cost to ship you a pair
Mod Dude
Aug 25, 2016
27,827
10,508
203
polk county florida
Oct 21, 2017
#13
  • Oct 21, 2017
  • #13
Do not grease the back of the pads, you can try spray'n the back of the pad with blue brake anti squeel stuff but most pads now have a anti squeek pad built in, swapping the rotors is a good idea too, see if the sound follows the rotor.
 
Reactions: Neuron
A

ace305

Active Member
Dec 28, 2011
171
17
28
Oct 21, 2017
#14
  • Oct 21, 2017
  • #14
Awesome thanks. the pads do have the anit squeel pad on it. I will swap them around and see if that helps. thanks everyone for the advice
 
You must log in or register to reply here.

Similar threads

T
  • Locked
Ticking noise as I accelerate
  • tazman 46
  • Jun 24, 2025
  • 2010 - 2014 Specific Tech
Replies
1
Views
130
2010 - 2014 Specific Tech Jun 24, 2025
Noobz347
J
2004 Mustang 3.8L V6 vibrations above 65 MPH and differential leaks
  • joeybuddy96
  • Mar 16, 2026
  • SN95 V6 Mustang Tech
Replies
13
Views
383
SN95 V6 Mustang Tech Yesterday at 2:45 PM
joeybuddy96
J
A
2001 Mustang GT, scorched metal smell and noise from trans/diff?
  • AndyE2255
  • Dec 1, 2025
  • SN95 4.6L Mustang Tech
Replies
4
Views
399
SN95 4.6L Mustang Tech Dec 28, 2025
gkomo
L
1986 Manual Swapped 5.0 Misfire + Other odd issue
  • LinkedInLincoln
  • Aug 12, 2024
  • Other Auto Tech
  • 2 3
Replies
43
Views
3K
Other Auto Tech Sep 11, 2024
Noobz347
K
TKX Transmission Shifting Problem
  • KWC156
  • Jun 23, 2025
  • Other Auto Tech
  • 2
Replies
20
Views
2K
Other Auto Tech Apr 23, 2026
CAMTWO1070
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?