I need drag racing help

demononwheels

New Member
Jul 1, 2006
10
0
1
Texas
I have a 1993 lx vortech s-trim, 306 making 508 rwhp. I'll be having my first race with this new motor and still rusty on my launching of the line.
Seems like I'm having supercharger lag. Any tips on what rpms to launch at.
Tire pressure? I have MT ET STREETS.
Need some tips.
Thanks
 
90mustangGT said:
I would start low, and bring the rpm up each pass until you find the right spot.

Bascially.

Assuming you are running at a track where you can get a good 6+ runs in a night, just start out at 2-3K rpm slipping/dumping the clutch off the line, and move up in rpm until you are having traction issues out of the hole. With ET streets and assuming your rearend/suspension is set up right, I'd figure you should be able to cut some 1.9/2.0 sec 60 ft. times your first time out. Practice makes perfect.

You want to run through first gear with as little tire spin as possible, but always sacrifice slight tire spin for bogging.
 
try launching in 500 rpm incriments. if you spin off the line constantly then lower the air pressure in your tires. i run mt drags and i run 10 psi in them. I don't make 506 ponies however. if you run lower psi be carefull how you come off the gas pedal at the end of the track. if you come off fast and you are not used to the feel of the tires it can make for a little bit of a scare.