In Search of... Rack and Pinion Info

this is a pic, its been on my site for months, hope it helps.

http://www.trinitysmustangs.com/images/cto.jpg

i don't see a lot of difference between the cavalier rack and the intrepid rack, they could be almost identical, although if i were to see the two of them side by side i'm sure i would find quite a few differences. i'm guessing it'll be mostly dimensional.

any body think a big cars rack would work, like a caddy or lincoln. their rack travel must be longer then a escort/ tempo.
-fred

Fatman's

Here's a link to Fatman Fabrication. His kit includes coil-over conversion along with the rack and pinion conversion.

Fatman's Strut Suspension for Pony Cars

I am seriously considering this kit! I saw a similar setup in Nashville that an Aussie was selling for $3G's

Hey Hakan, the square section bits that the tie rods bolt to, are they welded into the bar, or did you start with some square section bar and machine it round??
Thanks
Ben

well ready my jegs cat. I saw that they sell a after marked pinto rack system, it is
3 &3/4 turns for full travel. if someone could see how many turns there original steering has. we maybe able to get it to work.
-fred

Fred.....turns lock to lock don't mean squat.....it is the overall linear travel of the rack that is important and it needs to be around 7 inches IIRC, maybe a little more.

ok well just throwing ideas out there,, so if I wanted to find out the total travel for a rack I do this how,, jack the car up and measure what. wheel travel from ful left to full right? or do I need to be able to see the rack and measure there.
-fred

sorry just reread entire post and to measure corectly it is wheel travel from, lets just say left to right, I will see what I can measure this coming weekend.
-fred

CloneRanger said:

Hey Hakan, the square section bits that the tie rods bolt to, are they welded into the bar, or did you start with some square section bar and machine it round??
Thanks
Ben

Click to expand...

Nothing is welded, it´s made of a square bar that was machined.

I made a similar bar today for a ´65 Mustang convertible that I am putting a manual version of the r&p on. Will add pics at my website showing more of it later on.

http://speeddirect.com/index.aspx?nodeID=75

This is the one Sixto was working on. Thread here http://forums.stangnet.com/archive/index.php/t-128170

Sorry if this is repeat info.


Emailed the guys a couple of days ago and...

"We are still working on which headers will and will not fit - but it will fit with some."

"The rack we are using is a power rack, but it is internally lubricated, so
you can run it manually. Cost looks like it will be between $1K and
$1200 -depending on if you want a steering column with it. If you have any other questions, feel free to contact us!"

"...Flaming river tilt column."

Josh