Intake manifold...

[Unreal281]

I'm buying a blower this spring...and right now i'm trying to get the car ready...I'm going to be selling my accufab 75 mm throttle body and plenum...steeda pullies...and steeda intake...so i can make room for the vortech and bullitt manifold....

ONE PROBLEM...

I'm not spending almost 2000 dollars for that damn intake....


where can i get it cheaper???:SNSign:

 

[Dragstr05]

Wait for the trick flow. I believe its supposed to be out early 2007 (like february), bolts right in using all the stock locations and components, and I believe is in the 700-800 range, and will likely flow better than the bullitt.

 

[BlueRuckus]

Wait for the trick flow. I believe its supposed to be out early 2007 (like february), bolts right in using all the stock locations and components, and I believe is in the 700-800 range, and will likely flow better than the bullitt.

You have any more info on this?

 

[mity2]

You have any more info on this?

do search. there were couple of lengthy threads about this recently

 

[Unreal281]

That sounds really interesting...any other information you have about that? Will i be able to use my accufab throttle body/plenum combo?

 

[Tim2002GT]

Unreal281
That sounds really interesting...any other information you have about that? Will i be able to use my accufab throttle body/plenum combo?

If I remember right, the trick flow kinda has its own plenum. The throttle body would be great for it though.

 

[GDawg]

Between the price you are spending on the blower and the intake you can get a Kenne Bell and keep the 75mm TB.

 

[Kilgore Trout]

Yes, a twin screw KB or even FRPP will eliminate the need for a Bullitt or other upgraded intake manifold.

You should consider that...

 

[four six]

Kenny Bell