Engine Is my Top end combo good?

Mattymcg · Jul 27, 2019

Im debating if my top end combo is good or not
i seem to not have a lot of power like i should
i will be getting it dynod soon but beforehand i would like to know if there is change i can do that will benifit.
last time ran on the 1/4 it did 13.7 at 100 mph

stock 302 bottom end

heads : https://www.summitracing.com/int/parts/edl-60255
edelbrock 190cc

cams: https://www.summitracing.com/int/parts/edl-7122
edelbrock 7122

intake: https://www.summitracing.com/int/parts/edl-7521/overview/make/ford
edelbrock rpm air-gap

holly 600cc double pump

kit msd hvc

headers long tube bbc with 2.5`` exhaust.

JD1964 · Jul 27, 2019

Just curious but what's your 60' time? And what transmission are you running?

The parts combo you list does not necessarily look bad. To get the most of that cam you would need to come off the line with the rpm at about 3000. I'm wondering if you have traction problems or have a poor 60' time. The 60' is really important. One tenth lower 60' equals two tenths lower ET in the 1/4 mile.

FastDriver · Jul 27, 2019

@Noobz347 @a91what

This is not a tech thread. Plus, you already have a talk thread going on this exact same issue.

Help Me Go Fast In My FoxBody

So i bought a Foxbody last week with a Loads of modifications but nothing seems to be well set. Basically this is what is done to it 302 Heads Eldelbrock rpm valve 2.02'' 190cc with springs pushing rods solid lifter eldelbrock cams eldelbrock 7122 Carb holly 600cc intake eldelbrock kit...

www.stangnet.com

Engine Is my Top end combo good?

Mattymcg

New Member

JD1964

there is enough sticking out to grab on to

FastDriver

I was uncomfortably high & wearing a helmet

Help Me Go Fast In My FoxBody

Similar threads

Engine Is my Top end combo good?

Mattymcg

New Member

JD1964

there is enough sticking out to grab on to

FastDriver

I was uncomfortably high & wearing a helmet

Help Me Go Fast In My FoxBody

Similar threads

Privacy & Transparency

Privacy & Transparency