Is this intake ported? Pics + random pics!

[TomCat]

Here are a couple shots of my lower intake I pulled off a while ago. Looking it over, kinda seems like it's been ported, but I don't have a stock one to compare it to!


The second one shows where it seems to have been repaired with some putty or something... must be ported?

Here's a shot of my car... still undergoing repairs, but it looks a lot better than when it had its front end all mashed up



Working on the GT40Ps... gotta shim the springs and they're just about ready to go on.

And finally a pic of the little Probe GT engine I'm working on... goal is 320 lb/ft at the wheels and only 2600 lbs to move around. Fun car, needs lots of body work And yes... that's JB Weld holding the BOV on Getting a nice welded piece when I'm done with the body.


I know my cam is kinda sucky and the pics are small, but if you clicky on them... bigger! Yes, I'm bored.

 

[blackened88lx]

It's kinda hard to tell from those pics, but it does look like it might be ported. If it's not, it will have a rough cast look. If it's ported, it will have obvious grind marks.

 

[TomCat]

Ah, then it must be... thanks.

 

[85_SS_302_Coupe]

Definitely looks hogged out to me. It's pretty thin around the gasket area.

 

[5spd GT]

Definately looks ported to me