So I used a 36-1 wheel and spacer kit from 64-bit tuning with the aftermarket balancer it made belt alignment easy. The sensor is a hall effect I had sitting around, the same one can be purchased from diyautotune. I took a timing pointer and modified it with some sheet metal for the sensor mount. Works great.
I searched and searched for options on a crank trigger for a 94/95 serpentine belt type setup. After hours of searching the only direct bolt on kit i saw was over $700 from inovatorswest.com which was a balancer with magnets machined on the front and some expensive brackets and sensor. I had...
www.stangnet.com
Another 94/95 bug bite.
Looks like I need the following to do this if I wanted it between the balancer and pulley.
1. Diyauto 6.75 wheel
2. DIY auto threaded sensor
3. Innovators west .300 spacer
4. Machine down balancer .300 plus
Major pain.
Any reason I could not mount out in front of the pulley with some spacers?