like dropping anchor mid-track

glxrustang

New Member
Jun 17, 2004
3
0
0
Indiana
Okay, I have all high rpm parts, and falling on my face at high rpm..what gives?! 302 flat top pistons, 210cc Aluminum heads, funnel web intake, 750 DP with a proform mainbody, and f303 cam(which might be the problem). Also a transbrake, 3300 stall convertor and 4.10:1 gears. All this equates to 14.7 ET constantly...

Now here's the paradox, with the E7 iron heads, performer rpm intake, e303, and 650 cfm DP the thing ran 13.9s. Thats with the T5 and 3.55:1 gears. This setup is more street and less race, but ran faster.

So what happens when valve springs are too weak? (i dont think i remember valve float) Or maybe my cam is installed too advanced(cuz I have surpising low speed torque). Or could it be lazy air flow(whatever the heck that is).

Does anyone have solution to this? Maybe an engine builder or something has an opinion. Its just not accelerating properly. Same sortof thing happened when my fuel filter was clogged, or when my secondaries weren't opening fully.

Thanks for looking
 
holley blue pump 114 gph(freeflow) and -8 feed and -6 return lines thru an aeromotive bypass regulator. I am wondering about the blue pump. I will add an A1000 since I will be adding a turbo this year. (Check out my cardomain site, page 2)

I've been told the funnel web is too extreme, but isn't it supposed to kill low end and boost top end? At what rpm would it really kick in? And if I use my GT45 turbo will that end the lazy airflow?

So far, blue pump and funnel web intake are the suspects...