line lock need help

surfsup

New Member
Jul 26, 2007
2
0
0
I have a 92 2.3 lx that I did the motor conversion on, the brake system is the 2.3
I bought a B&M line lock but not sure how to install it, my master cylinder has the left front line hooked to the bottom of the master, the other lines all go to the brake distribution box, so I don’t really no how the front brakes work, normally all lines run to the distribution valve and then to the wheels. How is the left run wheel being controlled for the right pressure? Any way, because of this set up I’m not sure where the line lock should be installed, any help would be great
also how the hell do you use that metal tube that b&m put in the box, it's supose the measure the brake line or fitting for the correct size line
__________________
 
Welcome to the screwed up work on Fox Mustang brakes! Basically, you need to block off the third port on the MC and tee the two front lines into the line lock. Here is a schematic a friend did on his installs. Hope this helps!

llsketch.jpg