Looking to finish off Nitrous install.. Need help.

I took the plunge..
I picked up the zex kit for the 2005 Mustang GT (obvious)
Bottle Warmer
2 Pod Pillar Gauge Mount w/ Nitrous Pressure and A/F (i know inaccurate)
MSD Window Switch 3000-6200rpm

Does someone make a nitrous accessory switch panel for the 2005 already?
If so can someone point me in the right direction?

Once installed will be getting a new dyno tune for nitrous usage. So I will have a NA tune and a Nitrous tune. Hoping to put some serious times down at the track.

Will post pics and videos when everything gets here and is installed.

Thanks in advance.

Locate the four wires that go to the throttle position sensor. The wires are located on the passenger side of the
engine’s throttle body assembly.
Tap into the YELLOW wire.

Hope this helps.

Zex kit comes with a t-tap connector.
So Im guessing strip some insulation and solder it in.. would do the job.