MAC Flowpath Install Problem Over Rear Axle...

Is the jack under the rear axle? If so, you probably don't have enough room to get the bent tube over the axle housing. I jacked up the car using the jacking points on the subframe at the rear of the car and supported the car with jack stands. This allows the axle to hang and creates a little more space between the body and the axle.

the macs will only use the top portion of the factory hangers. i wondered this when i installed my mac catback a few months ago. use the one i circled in the picture. and to get teh tube over the axle jsut jack up the body a little bit and it will go over nicley!

enjoy you will love the mac sound

-eric

http://forums.stangnet.com/attachment.php?attachmentid=20905

p.s. DONT CUT ANY PART OF THE HANGER OFF. i did this and had to get a new one from ford!! (stupid of me) just put the hanger right backl where is was factory and use the circled insulator to hold up the mufllers, they will sit straight and the other part of the hanger will not be in the way at all