I am in the process of finishing the C-4 swap on my Fox Body and am trying to figure out how to change the "Neutral Safety" wiring from the manual over to the C-4.
I have the micro switch on the shifter, however am trying to figure out which wires I should run to the switch.
It appears that there is some type of switch attached to the top of the old clutch pedal via a small cable. The switch has 4 wires coming out of it and I would guess this is what I need to tap in to...however I am not sure which wires to use.
Any help is greatly appreciated!!!
I have the micro switch on the shifter, however am trying to figure out which wires I should run to the switch.
It appears that there is some type of switch attached to the top of the old clutch pedal via a small cable. The switch has 4 wires coming out of it and I would guess this is what I need to tap in to...however I am not sure which wires to use.
Any help is greatly appreciated!!!