Just got off the phone with a "Performance shop" in the Dallas/Ft.Worth Texas area...and determined after this call, that I may sound like I'm from Mars.
I have a Moates Quarterhorse setup and licensed versions of Clint's Binary Editor and Engine Analyzer. While I'm making progress on tuning my 347 stroker setup, I was considering going to a Dyno, DataLogging runs, and making changes to squeeze every bit out of this engine in it's current dress.
At least one shop will charge $125/hr for dyno runs... that same shop will charge $550 for a complete tune and chip burn using SCT tools/products.
For the A9L computer that this Fox body uses, I would have expected these guys to have the ability to easily work with me.
I'd like to find a shop with an experienced person(s) who can look at a DataLog and then recommend changes, right then and there, I would implement those changes via the Binary Editor and QH combo... then onto the next dyno/datalog run. Use 1 hour... use 2 hours... I don't care.
Finding the expertise is more important to me than cost.
Before I start calling other shops, I want to see if my expectations are completely out of line...or because I'm not using SCT/Diablo, I'm not likely to easily find a shop interested in this work.
Any opinions would be appreciated.
I have a Moates Quarterhorse setup and licensed versions of Clint's Binary Editor and Engine Analyzer. While I'm making progress on tuning my 347 stroker setup, I was considering going to a Dyno, DataLogging runs, and making changes to squeeze every bit out of this engine in it's current dress.
At least one shop will charge $125/hr for dyno runs... that same shop will charge $550 for a complete tune and chip burn using SCT tools/products.
For the A9L computer that this Fox body uses, I would have expected these guys to have the ability to easily work with me.
I'd like to find a shop with an experienced person(s) who can look at a DataLog and then recommend changes, right then and there, I would implement those changes via the Binary Editor and QH combo... then onto the next dyno/datalog run. Use 1 hour... use 2 hours... I don't care.
Finding the expertise is more important to me than cost.
Before I start calling other shops, I want to see if my expectations are completely out of line...or because I'm not using SCT/Diablo, I'm not likely to easily find a shop interested in this work.
Any opinions would be appreciated.