MODS FOR 99 COBRA?
- Thread starter Red99CobraSVT
- Start date
1. Yes, a 275/40/17 Nitto Drag will fit fine on the 17x8 stock wheel. I have this combo, in addition to my Cobra R wheels. Slight buldge, no issues with the Nitto's.
2. O/r pipe...BBK, Magnaflow...a bunch of companies. Are you looking for an H or X design? Do you want a matching catback?
3. After gears, I did a chip because of other mods anyway. I "believe" but am not sure, that you can buy a calibration module to compensate for the gear change. All my buddy's and I have chips, so I can't help further than that.
2. O/r pipe...BBK, Magnaflow...a bunch of companies. Are you looking for an H or X design? Do you want a matching catback?
3. After gears, I did a chip because of other mods anyway. I "believe" but am not sure, that you can buy a calibration module to compensate for the gear change. All my buddy's and I have chips, so I can't help further than that.
i have a mac cat back exhaust so which hpipe or x pipe would be better??i would prefer a cheaper one.how much for a xpipe for 99 cobra with no cats?also after the gear change how do i get the speedo true??and how much for this?i havent had time to really run this car much so about what rpm to launch on street tires for a good run?these 4.6s doesnt have much down low..
pro chamber
well since you already have Mac catback why not go with the pro chamber you can find a cheap one here in the classifieds section I dont think you will find a better x/y/ H- pipe for this car other than PROCHAMBER.
I remember reading that it gives the cobra like 22 HP/ just sold my old one to my brother for his GT and it sounds badazz".
well since you already have Mac catback why not go with the pro chamber you can find a cheap one here in the classifieds section I dont think you will find a better x/y/ H- pipe for this car other than PROCHAMBER.
I remember reading that it gives the cobra like 22 HP/ just sold my old one to my brother for his GT and it sounds badazz".
