This is my first time pulling a motor on a 5.0.
1) I'm seeing a lot of wires atop the engine. I have disconnected the wiring harness at the two sockets by the upper intake manifold, as well as all the ground straps. Which other wires do I need to remove? There's such a jumble of wires at the top, back of the engine that I don't know what goes where and what I need to remove before pulling the engine.
2) Where should I connect the chain? Should I connect it to head bolts?
3) Stupid questions, but what's the easiest way to d/c the throttle linkage and cruise control?
Thanks!
1) I'm seeing a lot of wires atop the engine. I have disconnected the wiring harness at the two sockets by the upper intake manifold, as well as all the ground straps. Which other wires do I need to remove? There's such a jumble of wires at the top, back of the engine that I don't know what goes where and what I need to remove before pulling the engine.
2) Where should I connect the chain? Should I connect it to head bolts?
3) Stupid questions, but what's the easiest way to d/c the throttle linkage and cruise control?
Thanks!