As stated my new 7qt moroso oil pan is interfering with the cutch cable where it attaches to the bellhousing.... there seems to be no way to get the retaining part of the cable seat in its location on the Bellhousing, even when filing the interfering points.
Has anyone had this issue? how has it been resolved?
thinking about fabbing a bracket to hold it just off the side using the original hole where it should be as an anchor point for the bracket, but im not sure if the angle to the clutch fork will have a conflict.
Has anyone had this issue? how has it been resolved?
thinking about fabbing a bracket to hold it just off the side using the original hole where it should be as an anchor point for the bracket, but im not sure if the angle to the clutch fork will have a conflict.