motor swap

Don't worry about it, there are too many haters in here about swapping a chevy engine in a ford

I know it's a little out of stretch but there are a few LS1 94-04 mustangs out there, over on ls1tech.com, one of the guys fitted the LS1 and it fit great in there with changing one bolt on the motor mount


Can't really help you about the swap though

By the time you get that motor swapped in its not going to be any cheeper. Is your existing motor blown up or something? If you get a built short block and a blower youll have all the power you could ever use on the street. How much power do you want?

by 350 i'm guessing you mean an old iron carbed setup. if so then i doubt you'll find any useful info as this is a horrible idea and i don't think anyone is that, well, let's just say it's just a bad idea. possible? of course but you might as well ask how to put a carbed 350 sideways into a 2000 civic si

if you mean a fuel injected all aluminum genIII LSX engine then i think it's a cool idea and like mentioned before, i'm sure you can find info on it. this is very expensive so i'm sure you're looking into the first idea

if you want a faster car, spend $4k total on a blower and have a 400+hp car you can drive everyday and be done with it, or sell the GT and buy an old 3rd gen fbody or a monte carlo or something. faster and cheaper


bottom line is doing unique swaps like this usually end up being more expensive in the long run. remember there's a reason it's not more common