Hello,
I have a 1967 Mustang Hardtop and I am starting the preparation of the engine. Firstly I bought an 302 from a 1969 Mustang and now I am aiming in a preparation that give me around 400HP. The car will be used on streets, maybe once a week just for fun. To achieve this power I was thinking to put the following items:
- carburator : Holley 750cfm
- intake manifold : Edelbrock Victor Jr. Intake Manifolds 2921
- cylinder heads : Edelbrock Performer RPM Cylinder Heads 60255
- cam : Thumpr Hydraulic Flat Tappet Camshaft Complete Kit Lift .491"/.476" Duration 279/296 RPM Range 2200-5800
- kit stroker : Scat 1-94165 - Ford 302 Series 9000 Cast Street/Strip Rotating Assembly 347ci
- water pump : FlowKooler Hi-Flow Mechanical Water Pumps 1650
- oil pump : Ford Performance Parts High-Volume Oil Pumps M-6600-D2
- coil : PerTronix Flame-Thrower II Ignition Coils 45011
- Distributor : PerTronix Flame-Thrower Plug and Play Billet Distributors with Ignitor II® Module D130700
Since this is my first project and I live in Brazil (so I have to import all the parts), I would like to know some opinions and tips about this setup.
Thanks
I have a 1967 Mustang Hardtop and I am starting the preparation of the engine. Firstly I bought an 302 from a 1969 Mustang and now I am aiming in a preparation that give me around 400HP. The car will be used on streets, maybe once a week just for fun. To achieve this power I was thinking to put the following items:
- carburator : Holley 750cfm
- intake manifold : Edelbrock Victor Jr. Intake Manifolds 2921
- cylinder heads : Edelbrock Performer RPM Cylinder Heads 60255
- cam : Thumpr Hydraulic Flat Tappet Camshaft Complete Kit Lift .491"/.476" Duration 279/296 RPM Range 2200-5800
- kit stroker : Scat 1-94165 - Ford 302 Series 9000 Cast Street/Strip Rotating Assembly 347ci
- water pump : FlowKooler Hi-Flow Mechanical Water Pumps 1650
- oil pump : Ford Performance Parts High-Volume Oil Pumps M-6600-D2
- coil : PerTronix Flame-Thrower II Ignition Coils 45011
- Distributor : PerTronix Flame-Thrower Plug and Play Billet Distributors with Ignitor II® Module D130700
Since this is my first project and I live in Brazil (so I have to import all the parts), I would like to know some opinions and tips about this setup.
Thanks