need help getting power to fuel pump

[95 Black Mamba]

Hey guy's could someone help me out here please?This is my project.I bought a 95 v6 mustang that i am putting a 6.2 escalade motor in.The v6 is out and the escalade motor is in.I left most of the factory wiring in place except for the wire's that ran to the v6 intake(sensors,throttlebody).When i hooked the battery back up after the swap all lights,starter everything else has power except the full pump.I was wondering if anyone knew the exact color wires in the factory harness that are for the full pump.

 

[HISSIN50]

At the pump, it should be pink/blk (positive) and blk (ground).

If you need the colors and pin numbers at the CCRM, post up.

Also be sure your inertia switch didnt trip.

Good luck.

 

[95 Black Mamba]

At the pump, it should be pink/blk (positive) and blk (ground).

If you need the colors and pin numbers at the CCRM, post up.

Also be sure your inertia switch didnt trip.

Good luck.

thanks for the reply i checked the switch(inertia)if thats the one in the hatchgoing out there right now to check the harness under the hood for the pink/black hopefully i can find it and run a switched hot to it or it could be as simple as a ground we'll see

 

[95 Black Mamba]

found the problem and got it going should be able to fire it up tomorrow

 

[toyman]

found the problem and got it going should be able to fire it up tomorrow

For the curious, the problem was!!!!

 

[95 Black Mamba]

For the curious, the problem was!!!!

i must of removed some wiring that powered the fuel pump,so i found the the fuel pump wire and had to run a switched hot to it

 

[madams74]

GM engine in a Mustang! I am vomiting. How could you? No, better yet, your an idiot, as Dr House would say.