New Exhaust installed but I have leaks??

Cobra1894

New Member

Oct 7, 2003

196

0

0

46

Broken Arrow, OK

Aug 7, 2005

#1

• Aug 7, 2005

• #1

I feel air coming out where the exhaust tubes connect to the X pipe Cats. I have the clamps on really tight but air is still escaping. Do I just need to install it again and shove the xpipe futher up to the header pipes or is a little air OK? Will this hurt performance?

 

At1Maverick69

Member

Aug 21, 2004

220

0

16

San Leandro, Cali

Aug 7, 2005

#2

• Aug 7, 2005

• #2

I think in one way or another it does hurt your performance, I'd say loosen the nuts and make sure it's sitting flush with each other, then try it again..

 

LilRedPony

New Member

May 12, 2003

31

0

0

Arizona

Aug 7, 2005

#3

• Aug 7, 2005

• #3

Maybe try loosening the bolts up some and using a hammer to tap the flange around to get it seated better. Even if it doesn't hurt performance smelling the exhaust all the time wouldn't be much fun.

 

M

Mysterio

New Member

Oct 6, 2004

101

0

0

39

Lakewood, Ohio

Aug 7, 2005

#4

• Aug 7, 2005

• #4

Make sure you don't fully tighten one side down. Slowly tighten each side bit by bit.. Did you do one side all the way tight then tighten the other side? That could make it not sit flush and let air out.

 

2

2002BLGT

Well-Known Member

Dec 18, 2003

2,945

4

59

Bedford VA

www.dirtydirtyracing.com

Aug 7, 2005

#5

• Aug 7, 2005

• #5

check the bolts and see if they are threaded all the way up to the head of the bolt , sometimes they give you shanked bolts that dont have threads all the way up and the nut will bottom out on the shank before it tightens the flanges up all the way ......you might have to go get some new bolts and bolt it up tighter , it should not leak if you do that .....

 

Cobra1894

New Member

Oct 7, 2003

196

0

0

46

Broken Arrow, OK

Aug 7, 2005

#6

• Aug 7, 2005

• #6

The connections are not flanged but they instead slipe in and have a clamp that secures it. The bolts have plenty of thread and there is only 1 bolt per side. I guess that I just need to slide the xpipe a little further onto the header pipes.