New Trick Flow Manifold Installed
- Thread starter smitty77
- Start date
my guess with this type of post and only 7 post at that, you could probably call 1-330-630-1555 or go to www.trickflow.com and see if you could find him 
Here are more specs
17.6" long
9.87" wide (frt of TB opening to other side)
7.5" tall
Plenum Volume approximately 250 cu in
Weight approximately 14.5lbs assembled
viton o-ring cord seal for the cover
gasket seal for the flange
cover is held down with (13) 1/4-20 ss button heads
flange is held on with (10) 1/4-20 allen
No egr provisions
90mm TB opening
(3) 1/8" npt holes for vac. fittings opposite tb opening
Reversable for driverside TB
Plenum hanges over the distributor about an inch
By no means is this information intended to be SPAM. I have not offered cut rate prescriptions drugs or tried to refiance anybodys mortgage. Leave me a PM if anybody has more questions
17.6" long
9.87" wide (frt of TB opening to other side)
7.5" tall
Plenum Volume approximately 250 cu in
Weight approximately 14.5lbs assembled
viton o-ring cord seal for the cover
gasket seal for the flange
cover is held down with (13) 1/4-20 ss button heads
flange is held on with (10) 1/4-20 allen
No egr provisions
90mm TB opening
(3) 1/8" npt holes for vac. fittings opposite tb opening
Reversable for driverside TB
Plenum hanges over the distributor about an inch
By no means is this information intended to be SPAM. I have not offered cut rate prescriptions drugs or tried to refiance anybodys mortgage. Leave me a PM if anybody has more questions
Jerry Leaming
Member
Smitty77 thanks for all your help Spam or not. At least somebody out there willing to give us valuable information on the intake.
If it helps one person it was worth posting on the Forum....
If it helps one person it was worth posting on the Forum....
Similar threads
