oh crap.....

88mustang92

Member
Mar 1, 2008
105
0
16
um...****??? idk this is very screwy, freshly built 1988 mustang 5.0 HO motor...had it done in december and have started it monthly..Started it yesterday n waited for her to get warm then reved it to about 3 grand then clunk clunk clunk...(shuts key off) I looked in my engine compartment and the top of my Timing Chain Cover is pretty much in pieces, n its only the top i have no clue wtf happened... I can see the chain if i go outside right now, i have already picked up the chunks that landed on the ground and under the car.. I have a new timing chain cover on its way so any thoughts?
 
well i do not think the timing chain snapped (double roller) b/c as i look down inside it seems like the chain looks fine and the cam is a B303 not even 3000 miles on it...when it was replaced all cam bearing were replaced and so was timing chain and gear...idk guys can't wait 2 tear into it..... so how bad i screwd up on my first motor.
 
I guarantee that little retainer plate that holds the cam in was not tightened down/loctited and came loose. As Matt stated, the cam probably just walked out, hit the timing cover, and did what it did.
 
here is the pic
 

Attachments

  • pci2.webp
    pci2.webp
    19.7 KB · Views: 187
This happened to someone else on here using a Trickflow timing set, something about them made it do that, I forget what happened. Sounds like something was left loose.

My TFS chain instructions said to countersink the bolt holes in the thrust plate (therefore making it weaker) and use the little phillips screws they supplied. wtf?:shrug:

Luckily I saw that thread :shock: so I didn’t follow their directions so my engine is still running strong after four months.
 
hey i was told by my dad there is a cetain slack in the chain that a manual tran car needs...is this true or how can u even adjust that...and also the bolt and the spacer that looks like a small L bracket cept its not as rigid (cam retaining bolt and other thing that goes with it to hold the gear into place) i placed the rounded end into the ovals in the gear...was that right? if not o **** and if so well cool.well any thoughts on the slack theory?
 
ouch...are you sure the chain didn't break and is just laying over the sprockets? sure looks like chain break carnage to me. :shrug: and yes there is a certain amount of slack that should be in the chain, but thats not specific towards manual tranny cars, and it's really not THAT much slack, espcially in a brand new chain. maybe an 1/8" flex each way?
 
got the cover 2day along with some felpro gasket 2day n took a chunk out of the old one 2day even though its still on the motor....i tried to life the chain off but it didn't seem 2 budge...i hope it gets nice soon i really want this car 2 run i have 2 many cocky supra friends with stock motors they keep braggin 2 me cuz my other stang is a 92 LX with a 2.3L.....sure good fuel economy but noooo power wen it you see it go past your house and i get on it it sound like this............(iiiiiiiiiiiiMMMMMMMM GAaaayyyyyyy) im like stfu ill put a 347 in you and change ur damn mind on saying **** like that lol well enough fantasizing time to get this motor running