this is my temp engine that's going in soon...
stock short block (little wear but not too bad - new main bearings)
F303 cam
C9TE heads (stainless valves 1.96 ( or 1.94, don't remember 100%)/1.6) good port job
1.6 roller rockers
windage tray
also trying to get a performer rpm intake
my current block is knocking and sucking up oil+coolant but I'm sending that one out to get properly done (347 build) hehe
stock short block (little wear but not too bad - new main bearings)
F303 cam
C9TE heads (stainless valves 1.96 ( or 1.94, don't remember 100%)/1.6) good port job
1.6 roller rockers
windage tray
also trying to get a performer rpm intake
my current block is knocking and sucking up oil+coolant but I'm sending that one out to get properly done (347 build) hehe