Overheating

oktw88

New Member
Jul 31, 2006
11
0
0
ok i have a 1990 Gt mustang. i have put a new 306 in all new cooling system and the car will overheat when i drive it like 5 miles or more. i have an electric fan and an autometer temp gauge. i have pulled the heads and took them to the shop and checked the head gasgets and everyting and it still overheats while driving.
 
Step one: Burp the system - With the car cold, take the radiator cap off. Check the coolant level (add the proper mixture until it's full.) Start the car with the cap off and turn the heater on. Check the level of the coolant. After a couple of minutes the level should drop, refill as necessary. Let the car get up to operating temperature after about 10 - 20 minutes the thermostat should open and the level will drop again. Keep refilling. Once you are sure it's full, take the car around the block slowly and let it cool down. Check the level and you should be good.

Note: Some people like to have the front of the car elevated so the radiator cap / opening is the highest point in the car to help traped air escape.
 
i was wondering could my fan not be big enough. it has a Perma-Cool High Performance Electric Fan that says it puts out like 2950 cfm. if i put a lincoln mark VIII fan would it cool down.
 
oktw88 said:
i was wondering could my fan not be big enough. it has a Perma-Cool High Performance Electric Fan that says it puts out like 2950 cfm. if i put a lincoln mark VIII fan would it cool down.
Does it run hot while idling, at speed, or both?
If it runs hot ONLY while idling (and cools off once you take off), the fan is a place to look.

Good luck.
 
oktw88 said:
i was wondering could my fan not be big enough. it has a Perma-Cool High Performance Electric Fan that says it puts out like 2950 cfm. if i put a lincoln mark VIII fan would it cool down.

Be careful with these fans. Put your hand in front of it and if it doesn't seem like it's blowing insanely fast, then it's wired incorrectly. These can be setup to push or pull. Which one are you doing? Do you know? Does it get warm just at idle or stop and go? Second, anyone who says you don't need a thermostat is a moron! You need one, get a Mr. Gasket 180, they are like $12. Then as stated above burp the system. Good method, is to slightly jack up the car on one side, pull the radiator cap and watch the bubbles. I usually let mine run for 45 minutes. Third, how old is the radiator? Stock? Stock water pump? Another good method to check the fan, is put you stock fan back on and see if it runs hot. Good luck!

Jason
 
HISSIN50 said:
Does it run hot while idling, at speed, or both?
If it runs hot ONLY while idling (and cools off once you take off), the fan is a place to look.

Good luck.

Not entirely true. Mine could idle for 12 hours in 115 degree heat and it would never get hot. When I drove it, THAT is when it heated up and could never bring temps down. Tossed the POS electric fan and put a junkyard stock fan on, car runs much cooler. Not one issue in the heat.
 
But JT's comment is true to a point.

When the car is sitting (parked) and running, the motor generates an increadible amount of heat. Without any air moving around the car, this heat has no where to go. Thus, the cooling system depends on the fan (mechanical or electric) to generate air flow over the cooling fins of the radiator to pull heat out of the cooling fluid. The cooled fluid is then circulated back into the engine to abosrb heat from the block and bring it back to the radiator. If the fan is not running at idle, there is no mechanism for heat transfer, thus leading to overheating. Or at least it is an extremely poor system.

When the car is traveling at speed on the highway the airflow around the car alone should be enough. Using the factory air dam air pressure builds up under the nose of the car creating a high pressure zone. Based on simple physics, this high pressure air wants to reach equalibrium with the rest of the air around it. So most of the high pressure air moves into the cavity directly above air dam, while some escapes under the bottom of the car. The air that once occupied the cavity is forced to find a new place to go. [or is pushed through the A/C condenser and Radiator] At the same time, this physics mechanism uses the air, looking for a new home, to grab heat from the radiator and move into the engine compartment. Once in the engine compartment, the air is sucked back out the bottom of the car like a vacuum.

Notice, that there isn't any mention of the fan in the second paragraph. That is because the ambient air around the car should be cool enough, and moving fast enough [highway speeds] on its own to properly cool the engine block. This is where a electrical fan has the advantage over a mechanical fan... The electric fan runs, but only when it has to. Thus giving you an increase in MPG's. Also, I am not taking into consideration ambient temperatures in acess of 100 degrees like those of the south west states.
 
srothfuss said:
But JT's comment is true to a point.

When the car is sitting (parked) and running, the motor generates an increadible amount of heat. Without any air moving around the car, this heat has no where to go. Thus, the cooling system depends on the fan (mechanical or electric) to generate air flow over the cooling fins of the radiator to pull heat out of the cooling fluid. The cooled fluid is then circulated back into the engine to abosrb heat from the block and bring it back to the radiator. If the fan is not running at idle, there is no mechanism for heat transfer, thus leading to overheating. Or at least it is an extremely poor system.

When the car is traveling at speed on the highway the airflow around the car alone should be enough. Using the factory air dam air pressure builds up under the nose of the car creating a high pressure zone. Based on simple physics, this high pressure air wants to reach equalibrium with the rest of the air around it. So most of the high pressure air moves into the cavity directly above air dam, while some escapes under the bottom of the car. The air that once occupied the cavity is forced to find a new place to go. [or is pushed through the A/C condenser and Radiator] At the same time, this physics mechanism uses the air, looking for a new home, to grab heat from the radiator and move into the engine compartment. Once in the engine compartment, the air is sucked back out the bottom of the car like a vacuum.

Notice, that there isn't any mention of the fan in the second paragraph. That is because the ambient air around the car should be cool enough, and moving fast enough [highway speeds] on its own to properly cool the engine block. This is where a electrical fan has the advantage over a mechanical fan... The electric fan runs, but only when it has to. Thus giving you an increase in MPG's. Also, I am not taking into consideration ambient temperatures in acess of 100 degrees like those of the south west states.

I hope you weren't explaining this to me. I am well aware of how a cooling system works, but I don't think you have the entire picture.

Sure, at idle the cooling system depends MORE on the fan, but remember...The car will still generate more heat under a load, not under idle. Thus a fan could be sufficient at idle, but not able to move enough air to cool the car under more "severe" lower speed conditions.

The fan is still used while the car is in motion as well. Lower speeds around town STILL depend on the air movement of the fan. Once highway speeds are reached, the fan's ability to pull air becomes less critical. Think of it this way. My car would NEVER get hot at idle. Once I drive in the city or around the back roads, temp goes up and goes up quickly. The car could then NEVER cool itself back down. Even with 5-10 mins of highway driving. Now, the only thing I changed was back to the stock fan/shroud and I have no issues at all? And no, its not headgaskets, I JUST replaced those.. and the thermostat... and water pump... etc.
 
I wasn't explaining it to you.. Just in the mood to type this morning. I do agree that the fan is used during low speed conditions such as in town or stop and go traffic. This is why the CFM of any fan is so important. If the fan you choose is too small, overheating in town will happen for sure. I choose the Mark Viii fan when I did my fan conversion and had no issues with overheating ever. But, I live in a climate that has moderate temperatures in the summer months.

I also wanted to spell out the imporatance of the factory air dam under the nose of the car. Most people just rip it off and wonder why their cars over heat.
 
Cman88 said:
The fan is still used while the car is in motion as well. Lower speeds around town STILL depend on the air movement of the fan. Once highway speeds are reached, the fan's ability to pull air becomes less critical. Think of it this way. My car would NEVER get hot at idle. Once I drive in the city or around the back roads, temp goes up and goes up quickly. The car could then NEVER cool itself back down. Even with 5-10 mins of highway driving. Now, the only thing I changed was back to the stock fan/shroud and I have no issues at all? And no, its not headgaskets, I JUST replaced those.. and the thermostat... and water pump... etc.
Sounds to me like a tired radiator that's unable to disapate heat rather than a fan issue. I had a simular issue that was more than resloved with a new 2 core. With the new rad in place, anything over 20MPH and temps were comming down without my Efans assistance unless temps were well into the 90's plus.
 
DMAN302 said:
Sounds to me like a tired radiator that's unable to disapate heat rather than a fan issue. I had a simular issue that was more than resloved with a new 2 core. With the new rad in place, anything over 20MPH and temps were comming down without my Efans assistance unless temps were well into the 90's plus.

I had the radiator checked by a reputable shop in the area.. They said it was in fine shape. I even tried some stuff to remove corrosion and rust from the cooling passages. Nothing helped but the stock mechanical fan. I might agree with you if the fan didn't make such a HUGE impact in the cooling of the car. The stock mechanical fan moves a lot more air then this electric one. Not to mention the electric one has a very small shroud and doesn't cover the whole radiator. It covered maybe 2/3rd's at best.
 
DMAN302 said:
Sounds to me like a tired radiator that's unable to disapate heat rather than a fan issue. I had a simular issue that was more than resloved with a new 2 core. With the new rad in place, anything over 20MPH and temps were comming down without my Efans assistance unless temps were well into the 90's plus.

+1 Radiator for Cman- I've had junk in my cooling system cause that problem too


Oktw- First like stated before- burp it, then Go to an oil change place or a shop and have the coolant flushed, I don't mean changed, I mean flushed. You can also take out the thermostat one day soon and check for corrosion. If you find no corrosion, and the flush doesnt help, there are no leaks, the guage is hooked up correctly, electric fan is spinning correct direction and the system is burped then repost this thread. I bet you won't have to cause it sounds like air in system as stated before :nice:
 
I'm in Arizona (about 1/4 mile from the sun) and just replaced the radiator and fan clutch, and now it won't get over 190 with the A/C on when it's 117 out.

I was amazed at how much air the stock fan moved with the new fan clutch. This was probably the main problem I had.

The new 3-row radiator helped too.

New radiator and new fan clutch cost about $220, but it was money well spent and was a quick and easy solution.
 
I stand by my first post - if the car only runs hot at idle (and no other time), the fan is the place to look. That's what I said.

Nice spin Cman - your situation is not the same as I outlined in my post (seems rather opposite, as a matter of fact).



Good luck gettin it sorted out. :cheers: