Progress Thread Please help Have no clue what this is can someone help

L

lsubadboy

New Member

Oct 19, 2004

28

0

1

Jan 16, 2019

#1

• Jan 16, 2019

• #1

Can someone tell me what this is and is it suppose to be loose I can pick it up where the bolt is and move both sides up and down is this something that needs to be tight or does it have bushing in it that may be worn or is it normally supposed to move up and down it really just don’t seem like it’s doing any thing right now it’s behind the drive shaft next to the rear end

 

RaggedGT

Been here over a DECADE and still no CT

Mod Dude

Jul 20, 2014

4,739

3,188

203

Taylorsville ky

Jan 16, 2019

#2

• Jan 16, 2019

• #2

It’s a pinion damper-helps with low speed vibrations-the bolts have probably just backed out-have you tried to tighten them up?

 

L

lsubadboy

New Member

Oct 19, 2004

28

0

1

Jan 16, 2019

#3

• Jan 16, 2019

• #3

RaggedGT said:

It’s a pinion damper-helps with low speed vibrations-the bolts have probably just backed out-have you tried to tighten them up?

Click to expand...

No I havnt done anything with it I still have it on the lift but I just noticed it today I was looking and noticed I could move it up and down but I didn’t know if it’s supposed to be loose or tight I will try to tighten it up tomorrow to see do they go bad or have to replace anything on them so it should fit snug and not move up and down right is there any bushing in it that need to be replaced

 

RaggedGT

Been here over a DECADE and still no CT

Mod Dude

Jul 20, 2014

4,739

3,188

203

Taylorsville ky

Jan 16, 2019

#4

• Jan 16, 2019

• #4

They usually fit pretty snug,but after 20 years I guess they can get a little loose lol.

 

L

lsubadboy

New Member

Oct 19, 2004

28

0

1

Jan 16, 2019

#5

• Jan 16, 2019

• #5

Lol ya I guess it has been on there a good while I will go out tomorrow and tighten it I just didn’t know what it was and if it was supposed to be like that I didn’t want to go tighten it and it was supposed to be loose but thanks for the help I’m glad there are people on here who know things so is there bushing inside the holes u have to replace