I have a set of GT40s that I bought used but they have new springs and have been cleaned up.
I am not sure of the spring rate so I'm hoping the shop can tell me this.
I'm going to send them to a machine shop to be checked out and possibly ported and polished.
What I need to know from you is what to have done to them for maximun potential.
I would also like to have the compression bumped up a tad but again I'm not sure what compression ratio I should be shooting for.
These heads will be coupled with a Cobra Intake (lower ported hopefully by TMOSS) and a OTS cam that I need your sugesstions on also.
I have a set of 1.7 roller rockers that I'm hoping to use also.
I'm hoping to make around 265-270 RWHP.
Is this possible with the parts I have?
I'm open to all comments and sugesstions.
If possible I do want to use the parts I have on hand as this will be a budget build-up but I will consider changing.
Bottom line with the machine shop is I need to know what to ask them to do to my heads.
Thanks
I am not sure of the spring rate so I'm hoping the shop can tell me this.
I'm going to send them to a machine shop to be checked out and possibly ported and polished.
What I need to know from you is what to have done to them for maximun potential.
I would also like to have the compression bumped up a tad but again I'm not sure what compression ratio I should be shooting for.
These heads will be coupled with a Cobra Intake (lower ported hopefully by TMOSS) and a OTS cam that I need your sugesstions on also.
I have a set of 1.7 roller rockers that I'm hoping to use also.
I'm hoping to make around 265-270 RWHP.
Is this possible with the parts I have?
I'm open to all comments and sugesstions.
If possible I do want to use the parts I have on hand as this will be a budget build-up but I will consider changing.
Bottom line with the machine shop is I need to know what to ask them to do to my heads.
Thanks