Please help with painless install

No Help!!

You have more patience than I do I bought one of their kits for my 67 what a piece of junk!! Took it out and bought a repo from california mustangs mucho grande!! :OT: :SNSign:

Funny

I just completed this step on my 66 Mustang this weekend. I must of read those instructions 2 dozen times. I also called Painless to ask them what wires go where on the wiper motor.

You have to remember that 3 or 4 of the wires, 2 from the fuse block and I believe 2 from the wiper pigtial are not used. Their for the 2 speed switch.

OK from the fuse block. You will not user either of the 2 black wires. The Orange and Black coming from the fuse block goes to terminal A.

The Lt Blue, Yellow, and White go to the wiper motor and the Lt Green goes to ground along with the black wire in that pigtail.


Now where exactly do those 3 wires go on the wiper motor, that was my question. If the wiper plug looks like this ....

.....I.....
...I...I... (just look at the I's I used the dots for spacers)


Then the wires are as follows.
Lt Blue, White, Yellow


Hope that helps?

Peter S.

hurt said:

Thanks again Pete for the wiper motor help, you don't happen to know how the Flaming River column wires up to the Painless Harness do you??? :SNSign:

Click to expand...

As far as the lights, I wired them exacly how Painless said to. And for the column, I only rewired the stock column.

Good luck.