power window getting stuck???

mojopony

New Member
Sep 9, 2007
71
1
0
What's involved in pulling off the door panel on an sn95? I don't see any clips or anything aside from one lone plug sort of clip at the lower front of the panel. I can run the glass down without much of a problem, but when I bring it back up it hangs up before fully closing.
 
You have to remove the plastic piece on th door where the lock and window button are. Use a flat head screwdriver and push in the tabs on the top of that plate. Behind it are 2 screws. Remove those screws and remove the screws that hold the lock and window button. Than you have to push up and out to remove the door panel. Have fun, its a pain in the a$$ to put it back on.
 
Door panels are easy as pie. I had to pull mine off today because the motor wasnt going up. Take the door cups off, pop the part behind the handle out, take off the pin you saw ans the plastic piece over the lock, and pull the panel up then out.
I wont lie it took me a good 20 minutes to get it back on my first time, but now its second nature. I need to change that motor. lol
 
Door panels are easy as pie. I had to pull mine off today because the motor wasnt going up. Take the door cups off, pop the part behind the handle out, take off the pin you saw ans the plastic piece over the lock, and pull the panel up then out.
I wont lie it took me a good 20 minutes to get it back on my first time, but now its second nature. I need to change that motor. lol

I have a drivers side motor if you need, $20 plus shipping and it's yours