Power window motor

Who are you callin' lady, bee'otch

The motor just unbolts with three nuts and a wire harness. I got mine out through the speaker hole. Install is opposite of removal.

Remove the door mounted speaker & the upholstery panel to gain access to the motor. There are 3 screws (5/16" hex head, I think) that secure the motor in place. Remove them and the motor comes out without any problems. Once you remove all the screws from the motor, and it falls away from the gear teeth on the arm for the glass, the glass will move up and down. You may need a helper to hold the glass once the motor screws are out, since the gear on the motor holds the glass from sliding up or down

The motor is the same for left side or right side, only the gearboxes are different. If you can't find the complete assembly for the side you want, you can get either side and use the old gearbox on the new motor.

When you first do it you will notice that after you take out the bolts, the motor may still be somewhat firmly attached to the door. Its hard to explain, but the gear on the motor has a dowel-thing that protudes maybe an 8th of an inch. Make sure that when you reinstall the new one it seats properly...you will see it when you take the whole thing apart. Good luck, its not too bad.