• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

Pretty significant oil leak, where could it be coming from?

  • Thread starter Thread starter SN95StangMan
  • Start date Start date Dec 7, 2005

SN95StangMan

New Member
Jul 5, 2003
1,292
0
0
Lynwood, CA
Dec 7, 2005
#1
  • Dec 7, 2005
  • #1
The other night I was coming home and the freeway goes uphill at a pretty decent angle. So, I punched it and noticed a huge plume of smoke behind me. So i just cruised slowly home, I busted out the flashlight and noticed a lot of oil on the right side of my car. All the way from the header collector, to the bend on my side exhaust. Now, the amount of oil towards the back of the car wasnt as dramatic, but towards the front, there was enought that it dripped off of my x-pipe. I lookd in the engine compartment and noticed a pool of oil behind the lower manifold. I dont think the seal back there is bad. I was thinking maybe a bad vavle cover gasket, but that seems like a buttload of oil for just a valve cover gasket. I needed new valve seals on a few cylinders anyhow, so that is going to be replaced. Where else could all that oil have come from? I doubt it is the rear main seal, because the oil is splashed around as high as the header collector. That, and I just replaced the old leaky seal a couple months ago. Maybe the PCV popped out, but it seemed to be in tact when i looked under the hood...

any suggestions would be greatly appreciated.
 

BPA

Founding Member
Aug 5, 2000
159
0
16
S.F.
Dec 7, 2005
#2
  • Dec 7, 2005
  • #2
Well maybe you have a bad muffler bearing , no but seriously.. Iwould try to find the highest point there is oil. Lower intake manifold or valve cover are very possible.. If you suspect eather and still are unsure you can always clean them down with brake clean( engine cold!) or degreaser. Run the engine after doing so and inspect for oil seapage or leaks.
 

a50sn95

Founding Member
Oct 12, 2001
368
0
16
Elk Grove, CA
Dec 7, 2005
#3
  • Dec 7, 2005
  • #3
Intake manifold rear valley gasket would be my guess....
 
F

fiveohh94gt

New Member
Dec 26, 2003
277
0
0
Dec 7, 2005
#4
  • Dec 7, 2005
  • #4
a50sn95 said:
Intake manifold rear valley gasket would be my guess....
Click to expand...
i second that
 

SN95StangMan

New Member
Jul 5, 2003
1,292
0
0
Lynwood, CA
Dec 7, 2005
#5
  • Dec 7, 2005
  • #5
I was leaning toward that too, except for the fact that theres no oil whatsoever on the drivers side of the car. That may be because only that corner of the rear manifold seal is leaking though, couldnt it??
 

urban96

bubb rubb says:"woo woooooo"
Founding Member
Sep 24, 2002
3,464
1
69
Syracuse, NY
Dec 8, 2005
#6
  • Dec 8, 2005
  • #6
also check your valve cover seal
 

xkuntrycowboyx

Member
Mar 31, 2005
281
0
17
Marion, Indiana
Dec 8, 2005
#7
  • Dec 8, 2005
  • #7
Your best solution at finding this problem would be to clean it up really well, all the oil. then lift ur hood, and fill er all the way back up with oil... start the car and watch for where it comes.
 

94GTLaserRC

Squint as you approach, lest you be blinded by my
15 Year Member
May 7, 2002
11,178
13
89
Ernan Says "here it comes... dushbag"
Dec 8, 2005
#8
  • Dec 8, 2005
  • #8
xkuntrycowboyx said:
Your best solution at finding this problem would be to clean it up really well, all the oil. then lift ur hood, and fill er all the way back up with oil... start the car and watch for where it comes.
Click to expand...


Oil leaks suck....Im still chasing one from 2+ years ago
RC
 

GRGT1994

New Member
Sep 22, 2004
1,034
0
0
Dec 8, 2005
#9
  • Dec 8, 2005
  • #9
Are you seeing oil on the header primaries too? If so, then I would suspect the valve cover, which can spew quite a good bit of oil at WOT (I can attest on personal experience).

If not, then I am with the rest on the rear lower manifold valley seal. BTW, mine is bad too.

Please post up as you have luck finding it. I'd be curious.
 

scarless

Member
Aug 9, 2004
175
0
16
Dec 8, 2005
#10
  • Dec 8, 2005
  • #10
Replace the valve cover gaskets first, they are easy and cheap. Then see if it is still leaking.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 8, 2005
#11
  • Dec 8, 2005
  • #11
If replacing valve cover gaskets, I would use the rubber over metal versions. Nice pieces that are reusable (they have ferrules in the bolt bosses to prevent distortion).

Good luck.
 

SN95StangMan

New Member
Jul 5, 2003
1,292
0
0
Lynwood, CA
Dec 8, 2005
#12
  • Dec 8, 2005
  • #12
94GTLaserRC said:


Oil leaks suck....Im still chasing one from 2+ years ago
RC
Click to expand...
Heh, your situation was the first thing that came to mind when I was looking for this...

Im going to clean it up and see what I can find. It's just a pain in the a$$ to try to get a good look back there. I was definitely going to do the valve cover before I try doing the manifold again. Ill see if I can get some pictures of this...
Thanks guys.
 

GRGT1994

New Member
Sep 22, 2004
1,034
0
0
Dec 8, 2005
#13
  • Dec 8, 2005
  • #13
BTW, I had to use lock washers to stop my VC screws from backing out. You might want to do the same while you have them off.
 

94GTLaserRC

Squint as you approach, lest you be blinded by my
15 Year Member
May 7, 2002
11,178
13
89
Ernan Says "here it comes... dushbag"
Dec 8, 2005
#14
  • Dec 8, 2005
  • #14
SN95StangMan said:
Heh, your situation was the first thing that came to mind when I was looking for this...

Im going to clean it up and see what I can find. It's just a pain in the a$$ to try to get a good look back there. I was definitely going to do the valve cover before I try doing the manifold again. Ill see if I can get some pictures of this...
Thanks guys.
Click to expand...
I just got her up on the stands, and got underneath with a good xenon white light...Sprayed a ton of brake cleaner to get the oil off (with a fan blowing the air out of the garage) then took it from there.
RC
 
You must log in or register to reply here.

Similar threads

J
Progress Thread Family member 1989 GT- Backstory and updates
  • JRC99
  • Apr 19, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
15
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 26, 2025
JRC99
J
W
Engine 306 oil leaks!
  • westernstar307
  • Jul 8, 2020
  • Fox 5.0 Mustang Tech
  • 2
Replies
28
Views
3K
Fox 5.0 Mustang Tech Jul 14, 2020
Monkeybutt2000
M
Engine Rear Engine Oil Leak
  • ragtop88
  • Jul 4, 2020
  • Fox 5.0 Mustang Tech
Replies
6
Views
2K
Fox 5.0 Mustang Tech Jul 19, 2020
7991LXnSHO
B
1982 Mustang 5.0 oil leak
  • bowman82
  • Jun 7, 2020
  • Fox 5.0 Mustang Tech
Replies
3
Views
809
Fox 5.0 Mustang Tech Jun 7, 2020
General karthief
D
Help! Mystery oil leak
  • Dakota82
  • Apr 6, 2020
  • The Welcome Wagon
Replies
14
Views
2K
The Welcome Wagon Apr 12, 2020
HarleyStang86
H
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?