Question About Factory 2008 Jack

sparx

Member
Sep 2, 2009
369
1
19
I decided to hang on to my 2008 Bullitt after all. There was nothing that would be better at this time.

So knowing the inflation kit is no good, I picked up a dognut spare tire kit off Ebay. I did not, was suppose to, receive the instruction card so I have a question.

What the heck is this threaded hood that is attached to the scissors jack for? I have not come up with a solution so far. (There is a fender washer keeping the hood from falling out inside the "U" channel)

Sparx

View attachment 118418

View attachment 118419

View attachment 118420
 
  • Sponsors (?)


Looks like the hook that holds down the spare tire. You have to take it off the jack.
uploadfromtaptalk1395441075689.jpg

Or the one that holds down the jack.
 
Last edited:
Yeah I see it there to the right of the main (larger) hooked bolt that runs through the center of the spare.
If I took it off the jack, how would it hold anything though?
TY for the image I appreciate it, at least I know how to put all the parts into the trunk well.
Jim
 
Thanks to ALL posters for the help, got the jack tested, just to be sure I know where the jack points were, and the jack, spare tire, etc. mounted in the trunk where I hope it stays for as long as I own the Bullitt!

:)
Sparx