question

[legalize420]

what needs to be done to change the motor mounts? i know i have read countless times about installing longtubes and jacking up the motor but is it enough to change the mounts. i might try it. what are my options? if i take it to a shop how many hours of labor should it be?

 

[wytstang]

Some what easy just jack the motor up (remove the stb) and remove and reinstall. You may have to loosen the tranny mount to get more height. Not to hard from what I remember...

 

[legalize420]

Some what easy just jack the motor up (remove the stb) and remove and reinstall. You may have to loosen the tranny mount to get more height. Not to hard from what I remember...

stb?

 

[legalize420]

so this can be done with the driveshaft in?

 

[wytstang]

STB=Strut tower brace
And yes I didn't have to remove the DS. Have a pry bar handy just in case one of the mounts needs some convincing.

 

[legalize420]

STB=Strut tower brace

that was taken off a while ago to make room for the cobra intake i will probobly get a new one when i start on my suspension next month.