Well hello everybody, long time no talk...
last time I posted, I was inquiring about track times on my car. It ended up going pretty damn slow, so I slapped on a set of GT40 heads....
Shortly after the initial test drive, I spun a rod bearing.
Not sure why, but oh well. its being pulled out soon. The motor already had low oil pressure,
assuming the motor just couldnt hang anymore.
My ultimate question is this-
I already have another shortblock that is .030 over with stock pistons, rods, etc.
I am going to swap my B cam over from my old motor into this one....
with a 150 wet shot, should I advance, retard, or keep the cam straight up?
I would like to do this motor as nicely as possible, and NO I will not buy a new cam. I believe the B cam is just fine for my application.
Setup is as follows-
Stock shortblock .030 over
GT40s, ported with stock valves/upgraded springs (unknown brand, they have red marks on intake and green on exhaust)
explorer heads/intake
B303
3.73 gears/T5
Longtubes with Hpipe/flowmasters
65mm TB
Any positive advice would be appreciated. thanks guys!
last time I posted, I was inquiring about track times on my car. It ended up going pretty damn slow, so I slapped on a set of GT40 heads....
Shortly after the initial test drive, I spun a rod bearing.
Not sure why, but oh well. its being pulled out soon. The motor already had low oil pressure,
assuming the motor just couldnt hang anymore.
My ultimate question is this-
I already have another shortblock that is .030 over with stock pistons, rods, etc.
I am going to swap my B cam over from my old motor into this one....
with a 150 wet shot, should I advance, retard, or keep the cam straight up?
I would like to do this motor as nicely as possible, and NO I will not buy a new cam. I believe the B cam is just fine for my application.
Setup is as follows-
Stock shortblock .030 over
GT40s, ported with stock valves/upgraded springs (unknown brand, they have red marks on intake and green on exhaust)
explorer heads/intake
B303
3.73 gears/T5
Longtubes with Hpipe/flowmasters
65mm TB
Any positive advice would be appreciated. thanks guys!