Being bored, I do what I normally do, and tinker with my car. I had an idea. What if you took a rubber insulation hose or flexable metal pipe and ran it from the gaps next to the foglights in the bumper up the location of where the air silencer normally goes (must remove it for this idea.)
So basicly, when you're moving fast, air is forced into the open end of the hose or tube thats located towards the bottom of your bumper. this cold rush of air goes through the tube and is "let out" right in front of the filter.
To see if it would flow well, I twisted up a very small diamater (I would use bigger for the car) rubber insualation hose thats just about the length you would need for this mod. I put a hair dryer on one end and put it on low. I put my hand on the end of the tube and could feel the air rushing out. It flows pretty well.
Now imagine that with a BIGGER diamater hose, while traveling 50 MPH with it pointed right out the front of the car.
So basicly, when you're moving fast, air is forced into the open end of the hose or tube thats located towards the bottom of your bumper. this cold rush of air goes through the tube and is "let out" right in front of the filter.
To see if it would flow well, I twisted up a very small diamater (I would use bigger for the car) rubber insualation hose thats just about the length you would need for this mod. I put a hair dryer on one end and put it on low. I put my hand on the end of the tube and could feel the air rushing out. It flows pretty well.
Now imagine that with a BIGGER diamater hose, while traveling 50 MPH with it pointed right out the front of the car.