• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Rear End "Pumpkin" Leaking

  • Thread starter Thread starter TheUser
  • Start date Start date Sep 17, 2005
T

TheUser

Active Member
Jul 25, 2003
1,859
1
36
Springfield, MO
Sep 17, 2005
#1
  • Sep 17, 2005
  • #1
My rear end in the 90 is leaking fluid. I searched and found threds about the top leaking where the driveshaft connects or something, but couldn't find anything similar to this. What exactly is causing this and how can I fix it? Is it real involved and time consuming?

 

RYC CUKR

Founding Member
May 19, 2002
1,437
1
38
Orlando
Sep 17, 2005
#2
  • Sep 17, 2005
  • #2
Fortunately there are only a few spots that 8.8 can leak. You could have a bad pinion seal. That would be behind the plate that the driveshaft connects to on the rear end. It would necessitate removing that plate. I have never had to mess with the pinion seal so I don't know the ins and outs of replacing one.

You could have a bad cover gasket.

Or you could be leaking from where the fill plug is. It is on the front of the diff on the drivers side. It is a threaded plug that uses a 3/8" drive ratchet to remove it.

The only other thing I can think of is a broken case.

More that likely I would think it might be a pinion seal.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Sep 17, 2005
#3
  • Sep 17, 2005
  • #3
James, if the area above the DS flange (where the DS bolts to the pinion) is clean, and there is no juice dripping out of the DS to pinion flange mating area (where the 12mm 12 pt bolts are), then it sounds like the pinion seal is ok.

I will note that on the cars that sit for a bit, they can start to leak a little - once driven and the seals are lubed, the leak seems to dissipate till the next non-run session.

And the stock pumpkin covers tend to flex - that can allow a tiny leak or seepage at the bottom of the pumpkin. A girdle is the way to deal with it, if the slight occasional dripping is bothersome.

Good luck bud.
 
T

TheUser

Active Member
Jul 25, 2003
1,859
1
36
Springfield, MO
Sep 18, 2005
#4
  • Sep 18, 2005
  • #4
it doesn't look too bad in that picture mostly because I cleaned a BUNCH of gunked up dried up grease/fluid a week or two ago. My main concern is running low on fluid, so I guess I'll see if I can find that hole and see how much is in there?
 

Realmongo

I prefer to be called "Evil Genius"
Founding Member
Oct 10, 2001
2,466
86
99
Western Mass
Sep 18, 2005
#5
  • Sep 18, 2005
  • #5
I found the same situation on mine. When I unbolted the driveshaft and pushed it into the transmission, I found the pocket area where the driveshaft bolts to the rear was filled with fluid. Turned out to be a bad pinion seal. The Chiltons manual details how to change this seal without disassembling the rear axle, but you will need an inch-pound torque wrench to perform it.
 

SCcopcar

Founding Member
Nov 21, 1999
326
0
0
Oklahoma
Sep 18, 2005
#6
  • Sep 18, 2005
  • #6
If the vent on top of the axle tube is stopped up it can also cause leaking.
 
You must log in or register to reply here.

Similar threads

9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
1K
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
Drivetrain Rear end clunk
  • seanmahoney
  • Oct 13, 2025
  • SN95 4.6L Mustang Tech
Replies
3
Views
523
SN95 4.6L Mustang Tech Oct 13, 2025
nickyb
2
Resolved Electrical mayhem
  • 2000ElectricGreen
  • Mar 13, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
3
Views
486
1996 - 2004 SN95 Mustang -General/Talk- Sep 4, 2026
2000ElectricGreen
2
B
Rear quarter window regulator
  • BADAZZOMBIE08
  • Mar 29, 2026
  • 2005 - 2009 Specific Tech
Replies
0
Views
236
2005 - 2009 Specific Tech Mar 29, 2026
BADAZZOMBIE08
B
M
Engine Unexplainable Exhaust Pop and Gurgle
  • Mrnissen122
  • Feb 14, 2026
  • Fox 5.0 Mustang Tech
Replies
12
Views
835
Fox 5.0 Mustang Tech Feb 18, 2026
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?