Hello
I know this may be a tired subject...but allow me to explain what specifically I am looking for.
1. I am looking information on how to remove the IRS springs (REAR) only.
2. I am looking for specific steps on how to remove and instal these springs by removing the upper control arm (UCA) knuckle/cross axis camber bolt and lowering the supported arm.
I am looking at step by step instructions for this method only...
What I am not interested in doing or talking about (PLEASE):
1. Compressing springs.
2. Removing the IRS rear frame bolt as H&R instructions suggest.
3. Anyone who thinks they might know how it is done by the method I am describing above...but doesn't know for sure.
I do not have a lift..the rear end is up on jacks and ready to go.
Thanks in advance to anyone out there who responds with REAL HELP!!
I know this may be a tired subject...but allow me to explain what specifically I am looking for.
1. I am looking information on how to remove the IRS springs (REAR) only.
2. I am looking for specific steps on how to remove and instal these springs by removing the upper control arm (UCA) knuckle/cross axis camber bolt and lowering the supported arm.
I am looking at step by step instructions for this method only...
What I am not interested in doing or talking about (PLEASE):
1. Compressing springs.
2. Removing the IRS rear frame bolt as H&R instructions suggest.
3. Anyone who thinks they might know how it is done by the method I am describing above...but doesn't know for sure.
I do not have a lift..the rear end is up on jacks and ready to go.
Thanks in advance to anyone out there who responds with REAL HELP!!