replacing cobra ignition module

hiimt0ny

New Member
Dec 29, 2005
13
0
1
Okay so i got the 95 cobra and i pull code 212. so im going to go ahead and change the ignition control module because im guessing it went out.

the one i have is dyna mod. i dont know if this comes with the car or not but i would like to get it again to replace this one instead of stock. unless the car already comes with this one stock. does the 5.0 dyna module work on cobras the same as on the regular 5.0's. and wehre can i get this module?
 
Dyna isnt stock. You can get them in the aftermarket however. Be sure to use heat sink grease upon installation. Be careful with it - too much inhibits the electrical connection and too little allows the module to run hot.

Good luck.