• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

replacing U joints...

  • Thread starter Thread starter stangGT97
  • Start date Start date May 29, 2005

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
May 29, 2005
#1
  • May 29, 2005
  • #1
well im pretty sure my U joints are shot, they're squeaking and my car is lagging something awful. anyone have any idea how hard it is it replace them? I picked up the parts already, im just debating whether or not to do it myself.

Also, 2nd question, my T-45 sucks and grinds a lot so I want to get it checked out, unfortunately I'll get charged about 300 bux to have a shop drop it and inspect. Does anyone know how hard it is to drop a transmission?
 

Turbo92PGT

Member
Feb 17, 2003
746
0
16
Auburn Washington
May 30, 2005
#2
  • May 30, 2005
  • #2
To drop the tranny you need to
1. disconnect the battery
2. disconnect the H pipe, support mufflers
3. Disconnect the starter and remove from block/trans
4. Drain transmission
5. Pull shifter out of trans
6. disconnect 4 bolts at rear end holding drive shaft on
7. Pull driveshaft out
8. Put plastic bag over transmission tailshaft to keep fluid from coming out
9. Put a jack under the "middle of transmission" (flat spot)
10. Remove two bolt holding the trans brace on (back of trans/frame)
11. Remove the 6 or 8 bolts on the bellhousing
12. Tech tip : Lower the back of the trans to get at the top two bolts
13. Once they are all removed double check to make sure there is no wiring in the way or anything
Get a friend and pull the trans out while its still in the jack, be careful

There ya go!! As far as the U joints, my dad replaced them, but I don tknow how
 

COramprat

...I can take it. I think.
20+ Year Stangneter
Mar 2, 2003
8,474
1,463
223
Sea of Tranquility
May 30, 2005
#3
  • May 30, 2005
  • #3
Worn U-joints will cause a vibration while moving. I'm not sure the symptoms you describe are the U joints.

It could be the clutch. The lag you describe is possibly the clutch slipping and the squeak you describe sounds like a bad throw-out bearing. When do you get the lag and squeak?

The tranny grind is probably the syncros. You could try a fluid change to see if it helps but it may just be a temp fix.
 

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
May 30, 2005
#4
  • May 30, 2005
  • #4
coramprat said:
Worn U-joints will cause a vibration while moving. I'm not sure the symptoms you describe are the U joints.

It could be the clutch. The lag you describe is possibly the clutch slipping and the squeak you describe sounds like a bad throw-out bearing. When do you get the lag and squeak?

The tranny grind is probably the syncros. You could try a fluid change to see if it helps but it may just be a temp fix.
Click to expand...

well i have some vibrations too, the clutch isnt slipping because the rpms stay constant, the car is just slow. also, the squeaking sound is not remedied by pushing in the clutch like most people say they do to fix the TOB squeak. thanks for the help guys
 
You must log in or register to reply here.

Similar threads

T
Drivetrain TREMEC TKX 1–2 Grinding Issue at ~4,000 Miles + Poor Warranty/Customer Service Experience
  • Ttopfoxguy
  • Oct 10, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
316
Fox 5.0 Mustang Tech Oct 15, 2026
JMG9350
J
Fox Fuel Pump Issues After Replacement/Upgrade
  • Ryu
  • Jun 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
24
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 13, 2026
Ryu
A
2001 Mustang GT, scorched metal smell and noise from trans/diff?
  • AndyE2255
  • Dec 1, 2025
  • SN95 4.6L Mustang Tech
Replies
4
Views
589
SN95 4.6L Mustang Tech Dec 28, 2025
gkomo
Y
2004 Mustang GT AUTO (4R70W) Grinding noise when going in R or Drive does it as I put it into park too
  • yellowandblack
  • Dec 12, 2024
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
388
1996 - 2004 SN95 Mustang -General/Talk- Dec 21, 2024
89ripper
S
Drivetrain 8.8 Pinion and 302 rear main seal leaks after replacing. 93 5.0 with t-5
  • Steigy4827
  • Jun 23, 2025
  • Fox 5.0 Mustang Tech
Replies
10
Views
878
Fox 5.0 Mustang Tech Apr 1, 2026
Steigy4827
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?