replacing U joints...

stangGT97

New Member
Dec 22, 2004
1,299
1
0
Boston area, MA
well im pretty sure my U joints are shot, they're squeaking and my car is lagging something awful. anyone have any idea how hard it is it replace them? I picked up the parts already, im just debating whether or not to do it myself.

Also, 2nd question, my T-45 sucks and grinds a lot so I want to get it checked out, unfortunately I'll get charged about 300 bux to have a shop drop it and inspect. Does anyone know how hard it is to drop a transmission?
 
To drop the tranny you need to
1. disconnect the battery
2. disconnect the H pipe, support mufflers
3. Disconnect the starter and remove from block/trans
4. Drain transmission
5. Pull shifter out of trans
6. disconnect 4 bolts at rear end holding drive shaft on
7. Pull driveshaft out
8. Put plastic bag over transmission tailshaft to keep fluid from coming out
9. Put a jack under the "middle of transmission" (flat spot)
10. Remove two bolt holding the trans brace on (back of trans/frame)
11. Remove the 6 or 8 bolts on the bellhousing
12. Tech tip : Lower the back of the trans to get at the top two bolts
13. Once they are all removed double check to make sure there is no wiring in the way or anything
Get a friend and pull the trans out while its still in the jack, be careful

There ya go!! As far as the U joints, my dad replaced them, but I don tknow how
 
Worn U-joints will cause a vibration while moving. I'm not sure the symptoms you describe are the U joints.

It could be the clutch. The lag you describe is possibly the clutch slipping and the squeak you describe sounds like a bad throw-out bearing. When do you get the lag and squeak?

The tranny grind is probably the syncros. You could try a fluid change to see if it helps but it may just be a temp fix.
 
coramprat said:
Worn U-joints will cause a vibration while moving. I'm not sure the symptoms you describe are the U joints.

It could be the clutch. The lag you describe is possibly the clutch slipping and the squeak you describe sounds like a bad throw-out bearing. When do you get the lag and squeak?

The tranny grind is probably the syncros. You could try a fluid change to see if it helps but it may just be a temp fix.

well i have some vibrations too, the clutch isnt slipping because the rpms stay constant, the car is just slow. also, the squeaking sound is not remedied by pushing in the clutch like most people say they do to fix the TOB squeak. thanks for the help guys