rocker arm question... help please...

Vapors

New Member
Aug 26, 2005
39
0
0
Bakersfield
I have scorpion rockers with 1.7 ratio on gt 40 heads and they fell apart so i am replacing them with fms 1.7 rockers and i have never installed rockers and i was wondering how hard it is or if i need any special tools or what to torque the bolts to??? Any information will help... thanks...
 
I use a ton of Scorpions and have never had any issues at all, what fell apart? You need to figure out why? They will also stand behind there products.

When you swap to a different brand rocker you need to set them up all over again. Check preload, pushrod length, geometry, shims etc... All rockers pivot points are not the same just because they are the same ratio means nothing.