i have an autometer air/fuel gauge on the a pilller and it never reads anything but lean, even at WOT. could the gauge be broke or am i just running completly lean. if so what are some things that i should look at to try and correct this problem. mods include BBK finder intake, cobra intake, GT40 heads, E303 cam headers full exhuast w/ no cats or emmsions. pls help!
running lean
- Thread starter spryd94vert
- Start date
bill302
Active Member
its your 02 sensors they will not read correct because you need wideband 02 sensors. welcome to stangnet...
bill302
Active Member
don't know but i know your guage is incorrect without wideband 02 sensors is you engine pinging at wide open throttle is your check engine light on?
spryd94vert said:
What might cause you to run lean
let me count the ways jelly bean
1) GT comes from Ford kinda lean right off the bat
2) CAI could contribute
3) Still runnin the stocker fuel pump
4) Still runnin the stock inj's
There are four that quickly come to mind
If you got an afpr and its jacked up a god bit ...............
3 & 4 might not be hurting you too bad ... but still ......................
I would tell you to not be afraid to feed the beast with an ample supply of fuel
Even after saying all that ... I think it is strange you don't even see normal stuff when you are just putting around town
Grady
bill302
Active Member
you are probably good, if there is no pinging (detonation) also is check engine light on. and if your worried about a rich or lean condition you can install an adjustable fuel pressure regulator and tune it at a local dyno shop dynos usually run about $80 an hour. which is enough time to adjust fuel
Similar threads
