If you are crafty enough, you can probably add the jumper to the harness you already have.
It all depends on the level of "correctness" you want here.
Best - factory o2 harness wity correct pin
2nd best - repinned factory harness
Perfectly acceptable - modify your harness with a jumper
Ok method - jumper between two wires on engine harness
Hack - cut and splice the two wires
After you get this done, you need to check for voltage on pin 47 on the EEC. You want to do this because you run the risk of frying the EEC. Pull the computer out, set up a multimeter to test pin 47 to ground. Have someone crank engine over. No voltage, good to go. If you have voltage, your pin is wrong and needs to move.
If you am search "mustang o2 harness differences" there are a few good threads. It's not a complicated topic, but you need to pay attention or it can be an expensive mistake
Sent from my iPhone using Tapatalk